Do you have a question about the Yaber Y60 and is the answer not in the manual?
Connect the projector to a PC using a VGA or HDMI cable for display output.
Connect Android or iOS smartphones using MHL-HDMI or Lightning-to-HDMI cables.
Connect iPhone using a Lightning-to-HDMI cable and select HDMI as the signal source.
Connect Anycast to projector's HDMI port and power it via USB for wireless display.
Connect a DVD player using the supplied AV cable for audio and video playback.
Connect a soundbar using the supplied AV cable to enhance audio output.
Use screws to secure the tilt base and adjust the projector's front edge height.
Install a projector stand with a 1/4 inch screw to hang the projector on the ceiling.
Choose the input source like AV, PC-RGB, HDMI 1, HDMI 2, or USB from the remote control.
Select the desired OSD language from the OPTION menu during initial setup.
Access main menu options like Movie, Music, Photo, and Text.
Configure OSD Language, Reset, Blending, OSD Duration, Blue Screen, and Software Update.
Adjust Picture Mode (Standard, Soft, Vivid) and Color Temperature (Warm, Cool).
Set Aspect Ratio (4:3, 16:9) and adjust Noise Reduction levels.
Configure projection direction for desk or ceiling mounting, front or rear.
Select Sound Mode (Music, Movie) and adjust audio Balance (-50 to 50).
Enable or disable the automatic volume adjustment feature.
Set the Sleep Timer mode to Off, 10, 20, 30, 60, or 90 minutes.