EasyManuals Logo

Yaesu FT-450 Technical Supplement

Yaesu FT-450
69 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Introduction
This manual provides technical information necessary
for servicing the FT-450 HF/50 MHz Transceiver.
Servicing this equipment requires expertise in handling
surface-mount chip components. Attempts by non-qual-
ified persons to service this equipment may result in per-
manent damage not covered by the warranty, and may
be illegal in some countries.
Two PCB layout diagrams are provided for each double-
sided circuit board in the Transceiver. Each side of is re-
ferred to by the type of the majority of components in-
stalled on that side (“leaded” or “chip-only”). In most
cases one side has only chip components, and the other
has either a mixture of both chip and leaded components
(trimmers, coils, electrolytic capacitors, ICs, etc.), or lead-
ed components only.
While we believe the technical information in this manu-
al to be correct, VERTEX STANDARD assumes no liabili-
ty for damage that may occur as a result of typographi-
cal or other errors that may be present. Your cooperation
in pointing out any inconsistencies in the technical infor-
mation would be appreciated.
©2007 VERTEX STANDARD CO., LTD.
Technical Supplement
HF/50 MHz TRANSCEIVER
FT-450
Contents
Specifications
Exploded View & Miscellaneous Parts
Block Diagram
Connection Diagram
Alignment
Board Unit (Schematics, Layouts & Parts)
RF-IF Unit
PANEL Unit
CNTL Unit
PA Unit
TUNER Unit ATU-450 (Option)
VERTEX STANDARD CO., LTD.
4-8-8 Nakameguro, Meguro-Ku, Tokyo 153-8644, Japan
VERTEX STANDARD
US Headquarters
10900 Walker Street, Cypress, CA 90630, U.S.A.
YAESU EUROPE B.V.
P.O. Box 75525, 1118 ZN Schiphol, The Netherlands
YAESU UK LTD.
Unit 12, Sun Valley Business Park, Winnall Close
Winchester, Hampshire, SO23 0LB, U.K.
VERTEX STANDARD HK LTD.
Unit 5, 20/F., Seaview Centre, 139-141 Hoi Bun Road,
Kwun Tong, Kowloon, Hong Kong
VERTEX STANDARD
(
AUSTRALIA
)
PTY., LTD.
Normanby Business Park, Unit 14/45 Normanby Road
Notting Hill 3168, Victoria, Australia
EH024H90A

Other manuals for Yaesu FT-450

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yaesu FT-450 and is the answer not in the manual?

Yaesu FT-450 Specifications

General IconGeneral
Impedance50 ohms
Supply Voltage13.8 V DC
Supply Voltage Tolerance±15%
Image Rejection70 dB or better
Frequency Range Receive30 kHz - 56 MHz
ModesSSB, CW, AM, FM
AM Power Output25 W
Weight3.6 kg
Receiver Sensitivity SSB0.2 µV (12 dB SINAD)

Related product manuals