To Next PageTo Next Page
Need help?Do you have a question about the Yaesu FT-60R and is the answer not in the manual?
General| Frequency Range TX | 144-148 MHz, 430-450 MHz |
|---|---|
| Mode | FM |
| Antenna Impedance | 50 Ohms |
| Dimensions | 58 x 109 x 30 mm |
| Channels/Memory | 1000 channels |
| CTCSS/DCS | Yes |
| Receiver Type | Double-Conversion Superheterodyne |
| Frequency Range RX | 108-520 MHz, 700-999.99 MHz |
| Battery | 7.2 V, 1400 mAh Ni-MH |
| Weight | 370 g |
| Channel Steps | 5, 10, 12.5, 15, 20, 25, 50, 100 kHz |
| Sensitivity | 0.16 μV (12 dB SINAD) |
Details the primary controls for radio operation like antenna connection, volume, tuning, and squelch.
Steps for powering on/off, adjusting volume/squelch, and selecting operating bands.
Covers tuning frequencies, direct entry, scanning, and basic transmission procedures.
Configuring repeater shifts and enabling Automatic Repeater Shift (ARS).
Setting CTCSS tones and DCS codes for repeater access.
Procedures for storing, recalling, and organizing memories into banks.
Setting scan resume modes and performing VFO/Memory scans.
Excluding channels from scans and setting up preferential scan lists.
Operating on a main channel while periodically checking a priority channel.
Storing CTCSS tone pairs and activating the EPCS system.
Using the emergency feature and Automatic ID (EAI) transmission.
Configuring Smart Search modes and storing detected frequencies.
