To Next PageTo Next Page
Need help?Do you have a question about the Yaesu FT-950 and is the answer not in the manual?
General| Modes | SSB, CW, AM, FM, Digital |
|---|---|
| Receiver Type | Triple Conversion Superheterodyne |
| DSP | Yes |
| Antenna Impedance | 50 Ohms |
| Antenna Connector | SO-239 |
| Supply Voltage | 13.8 V DC ±15% |
| Power Output | 100 W (HF/50 MHz) |
| Current Consumption | 22 A (max) |
| IF Frequencies | 69.450 MHz |
| Image Rejection | 70 dB or better |
| Audio Output | 2.5 W into 4 Ohms |
| IF Rejection | >70 dB |
Provides the typical start-up procedure for normal operation of the FT-950.
Explains interference suppression features and their circuitry.
Provides steps for basic SSB and AM mode transmission.
Details how to adjust the SSB transmit power output.
Explains how to adjust the AM carrier power output.
Details the steps to activate and configure the equalizer.
Explains how to record and check voice messages.
Explains how to transmit recorded voice messages.
Explains using the FH-2 keypad for voice memory functions.
Details how to use the FT-950's built-in electronic keyer.
Introduces the Contest Memory Keyer for automatic CW message sending.
Explains programming messages using the FH-2 keypad.
Explains how to program messages using a keyer paddle.
Describes how to transmit programmed CW messages.
Describes transmitting messages using the FH-2 keypad.
Provides steps for basic FM mode operation.
Explains how to operate the FT-950 using repeaters, including CTCSS.
Details how to use Tone Squelch for receiver silence until a matching CTCSS tone is received.
Describes the FT-950's memory features, including regular, PMS, and QMB memories.
Explains how to store and recall operating parameters using the Quick Memory Bank.
Details memory storage, recall, status checking, and erasing.
Details how to transfer memory contents to the VFO-A register.
Details how to store frequency, mode, and status information into memory.
Explains how to recall stored memory channels.
Explains how to scan VFO frequencies for incoming signals.
Explains how to scan memory channels for incoming signals.
Explains how to access and navigate the transceiver's extensive menu system.
Details the installation of the DVS-6 Voice Memory Unit.
Describes the RF μTuning Kits for ultra-sharp RF selectivity.
Provides step-by-step instructions for installing the DVS-6 unit.
Explains the FC-40 tuner, its components, and capabilities.
Describes the DMU-2000 for Band Scope, Audio Scope, etc.
Details the connection of the FC-40 to the FT-950.
Explains how to configure the FT-950 and operate the FC-40 tuner.
