Yaesu FT-950 - SPECIFICATIONS; Receiver Specifications

Page 127FT-950 OPERATING MANUAL
SPECIFICATIONS
Receiver
Circuit Type: Triple-conversion Superheterodyne
Intermediate Frequencies: 69.450 MHz/450 kHz/30 kHz (24 kHz for AM/FM)
Sensitivity: SSB (BW: 2.4 kHz, 10 dB S+N/N)
4 μV (0.5 - 1.8 MHz) (IPO “ON”)
0.2 μV (1.8 - 30 MHz) (RF AMP 2 “ON”)
0.125 μV (50 - 54 MHz) (RF AMP 2 “ON”)
AM (BW: 6 kHz, 10 dB S+N/N, 30 % modulation @400 Hz)
28 μV (0.5 - 1.8 MHz) (IPO “ON”)
2 μV (1.8 - 30 MHz) (RF AMP 2 “ON”)
1 μV (50 - 54 MHz) (RF AMP 2 “ON”)
FM (BW: 15 kHz, 12 dB SINAD)
0.5 μV (28 - 30 MHz) (RF AMP 2 “ON”)
0.35 μV (50 - 54 MHz) (RF AMP 2 “ON”)
There is no specification for frequency ranges not listed.
Squelch Sensitivity: SSB/CW/AM
(RF AMP 2 “ON”) 2 μV (0.1 - 1.8 MHz)
2 μV (50 - 54 MHz)
FM
1 μV (28 - 30 MHz)
1 μV (50 - 54 MHz)
There is no specification for frequency ranges not listed.
Selectivity (WIDTH: Center): Mode –6 dB –60 dB
CW/RTTY/PKT 0.5 kHz or better 750 Hz or less
SSB 2.4 kHz or better 3.6 kHz or less
AM 6 kHz or better 15 kHz or less
FM 15 kHz or better 25 kHz or less
Image Rejection: 70 dB or better (160 - 10m Amateur bands)
60 dB or better (6m Amateur band)
Maximum Audio Output: 2.5 W into 4 Ohms with 10% THD
Audio Output Impedance: 4 to 8 Ohms (4 Ohms: nominal)
Conducted Radiation: Less than 4 nW
Specifications are subject to change, in the interest of technical improvement, without notice or obligation, and are
guaranteed only within the amateur bands.