To Next PageTo Next Page
Need help?Do you have a question about the Yaesu FT-920 and is the answer not in the manual?
General| Antenna Impedance | 50 ohms |
|---|---|
| Supply Voltage | 13.8 V DC ±15% |
| Current Drain RX | 1.5 A |
| Current Drain TX | 20 A |
| Memories | 99 |
| Modes | AM, FM |
| Receiver Type | Superheterodyne |
| Receiver Sensitivity | 0.25 µV (SSB, 10 dB S/N) |
| IF Bandwidth | 2.4 kHz (SSB) |
| Frequency Range RX | 100 kHz - 30 MHz |
| Power Output | 100 W (SSB, CW, FM), 40 W (AM) |
Details on frequency ranges, modes, power output, and modulation.
Details on sensitivity, selectivity, IF, and tuner range.
List of included accessories and optional items.
Inspection, power, location, and grounding guidelines.
Warnings on electrical shock, antennas, RF exposure, and compatibility.
Interfacing linear amplifiers and digital modems.
Connecting CW keyers, antennas, and computers.
Controls for basic operation, voice switching, and audio levels.
Controls for frequency tuning, step selection, and locking settings.
Controls for antenna selection, squelch, speech processor, and monitor.
Controls for noise blanker, VFO indicators, memory, and special features.
Controls for CW keying, DSP, antenna tuner, and interference reduction.
Jacks for CAT, PTT, keying, TR-RY, Tx GND, and power.
Jacks for peripherals, RF signals, and antennas.
Initial audio setup and antenna configuration.
Selecting operating modes and CW sideband options.
Adjusting bandwidth, selecting bands, and tuning frequencies.
Features to improve reception clarity and signal quality.
Controls for gain, squelch, and out-of-band reception.
Using SHIFT control and DSP filters to mitigate interference.
Using Notch, RF Gain, NB, and NR for noise suppression.
IPO and Attenuator for managing high signal levels.
Warning about connecting antenna/dummy load before transmitting.
Built-in tuner for matching antenna systems to the transceiver.
SSB setup, voice switching, and speech processing.
Different CW break-in modes and their operation.
Using built-in keyers and storing repetitive CW messages.
Using Clarifier and Split VFO for frequency separation.
Operating procedures for Mode K satellite communication.
Using AFSK with TNC for RTTY and Packet.
Utilizing FT-920's tone generator for FSK RTTY.
Steps for connecting mic, setting controls, and transmitting AM.
Basic FM simplex and repeater operation.
Storing and recalling standard memory channels (1-99).
Quick storage/recall (QMB) and easy-access (CALL) channels.
Storing and recalling split frequency memory channels.
Appending labels to memory channels for identification.
Basics of scanning and programming channels to skip.
Scanning within limits and customizing resume behavior.
Monitoring two frequencies simultaneously.
Accessing Normal, Panel, and Quick Menu modes.
Explains U-01 to U-14 settings for dials, steps, display, groups.
Explains U-15 to U-43 settings for scan, keyer, and RTTY.
Explains U-44 to U-57 settings for packet, preamp, ATU, and amp tuning.
Explains U-58 to U-73 settings for carrier, VOX, filters, and reset.
Explains phone patch linkage and requirements.
Describes manual PTT or automatic VOX control for phone patch.
Command to download frequency and memory channel data.
Command to download eight status flag bytes.
