Yaesu FT-950 - MEMORY OPERATION; Moving Memory Data to the VFO-A register; Memory Tune Operation

Page 92 FT-950 OPERATING MANUAL
MEMORY OPERATION
STANDARD MEMORY OPERATION
The Standard Memory of the FT-950 allows storage and recall of up to 99 memories, each storing frequency, mode, and a
wide variety of status information detailed previously. Memories may be grouped into as many as six Memory Groups, and
additionally you get nine pairs of band-limit (PMS) memories along with five QMB (Quick Memory Bank) memories.
Memory Storage
1. Set the VFO-A up with the frequency, mode, and sta-
tus, the way you want to have it stored.
2. Press the
[
A
XX
XX
X
M
]
button momentarily (the current chan-
nel number will start blinking in the Multi-Panel Win-
dow); the contents of the current memory channel will
be shown on the frequency display field.
3. Rotate the
[
CLAR/VFO-B
]
knob to select the memory
channel onto which you wish to store the data. If you
have selected a channel on which data is already stored,
that frequency will appear on the display.
4. Press and hold in the
[
A
XX
XX
X
M
]
button for one second to
store the frequency and other data into the selected
memory channel. A double beep will confirm that you
have held the
[
A
XX
XX
X
M
]
button in long enough.
Memory Channel Recall
1. Press the
[
V/M
]
button, if necessary, to enter the
“Memory mode”. A memory channel number will ap-
pear in the Multi-Panel Window.
ADVICE:
If you cannot enter the “Memory mode”, check the
[
VFO-B
(
RX
)]
Indicator/Switch. If it is illuminated
green, press the
[
VFO-A
(
RX
)]
Indicator/Switch to
make the
[
VFO-B
(
RX
)]
Indicator/Switch go out, then
press the
[
V/M
]
button again.
2. Press the
[
MCH
]
button. The orange LED inside the
button will light up, indicating that you are ready to
recall a memory channel.
3. After pressing the
[
MCH
]
button, you may rotate the
[
CLAR/VFO-B
]
knob to select the desired memory
channel.
ADVICE:
To work within a particular Memory Group, press the
[
GRP
]
button (the imbedded LED will glow orange), then
rotate the
[
CLAR/VFO-B
]
knob to select the desired
Memory Group. Now press the
[
MCH
]
button (the im-
bedded LED will glow orange); you may now choose the
memory channel within the selected Memory Group.
Multi-Display Window
[
V/M
]
Button
[
VFO-A
(
RX
)]
Button
[
VFO-B
(
RX
)]
Button
[
MCH
]
Button
[
GRP
]
Button
[
CLAR/VFO-B
]
Knob
[
A
XX
XX
X
M
]
Button
[
CLAR/VFO-B
]
Knob