Need help?Do you have a question about the Yaesu FT-757GX II and is the answer not in the manual?
General| Modes | SSB, CW, AM, FM |
|---|---|
| Receiver Type | Double conversion superheterodyne |
| Antenna Impedance | 50 ohms |
| Power Supply | 13.8 VDC |
| Type | HF Transceiver |
| Voltage | 13.8 V DC |
| Frequency Range | 160-10 meters |
| Power Output | 100 watts |
| RF Power Output | 100 watts |
| Receiver Sensitivity | 0.25 μV (10 dB S/N, SSB, CW) |
| Image Rejection | 70 dB |
| IF Rejection | 70 dB |
Detailed technical data for the transmitter.
Detailed technical data for the receiver.
Controls for power, microphone, audio, and RF adjustments.
Frequency tuning, interference reduction, squelch, and band/mode controls.
Dial lock, meter, clarifier, and RF accessory switches.
Power input, data signals, linear amp control, and delay.
Jacks for audio output, antenna, accessory power, and keyer.
Accessory power outputs and ground connection.
Controls for CW break-in, keyer mode, and speed.
Initial checks and base station setup procedures.
Connecting and optimizing the antenna system.
Vehicle power, antenna setup, and bracket installation.
Connecting and controlling linear amplifiers.
Powering on, tuning, and managing memory backup.
Optimizing SSB reception and reducing interference.
Noise reduction, squelch, and specific reception modes.
Procedures for SWR checking, measurement, and power calibration.
Settings for various transmission modes and speech processing.
VFO selection, memory storage, and split frequency operation.
Accessing, modifying, and scanning memory channels.
CAT system commands, timing, and status updates.
To Next Page
