Need help?Do you have a question about the Yaesu FT-757GX and is the answer not in the manual?
General| Modes | SSB, CW, AM, FM |
|---|---|
| Receiver Type | Superheterodyne |
| Antenna Impedance | 50 ohms |
| Supply Voltage | 13.8 V DC |
| Type | HF Transceiver |
| Power Output | 100 watts |
| Receiver Sensitivity | 0.25 µV for 10 dB S/N |
| Selectivity | 4.2 kHz (-60 dB) |
Details of the transmitter's frequency range, power output, and emission types.
Details of the receiver's frequency range, circuit type, and sensitivity.
Specifies voltage, power consumption, dimensions, and weight of the transceiver.
Lists supplied and optional accessories for the transceiver.
Lists integrated circuits, transistors, diodes, LEDs, and other electronic components.
Describes POWER, MIC, PHONES, MODE, and AF RF controls.
Explains tuning knob, SHIFT, WIDTH, SQL, NB, MIC DRIVE, and BAND/CH/STEP controls.
Details PMS (Programmable Memory Scan) and VFO/Memory selection keys.
Explains D LOCK, Meter/Display, CLAR, and METER/RF AMP push buttons.
Describes ATT, PROC, NB, AGC-F, MOX, and VOX buttons for signal and transmit control.
Details DC power input and BAND DATA connectors for accessories.
Explains LINEAR switch, DELAY, ANTI TRIP, and VOX GAIN controls.
Describes COMP LEVEL, AM CAR, MARKER, REMOTE, PTT, ANT, PATCH/AFSK, FWD-REV, FWD SET, EXT ALC.
Explains AF OUT, EXT SPEAKER, KEY, RF OUT, +8V, +13.5V, and GND terminals.
Guides on preliminary inspection, base station setup, and AC power supply.
Shows power supply visuals and lists warranty-voiding abuses.
Guidance on grounding, placement, and antenna connection.
Details mobile installation steps and critical safety cautions.
Guides on connecting linear amplifiers and related accessories.
Provides circuit diagrams for accessories like the FRB-757.
Illustrates connections for headphone, speaker, keyer, and RCA plugs.
Details the wiring and connections for MD-1B8 and MH-1B8 microphones.
Guides on initial power-up, tuning, and display indications.
Techniques for reducing noise and interference during reception.
Explains CW and AM reception modes and adjustments.
Details FM reception and RTTY operation using SSB modes.
Guides on checking SWR and calibrating the power meter.
Details SSB, VOX, Speech Processor, and CW transmission adjustments.
Explains FM transmission and cautions for high-duty transmission.
Guides on AM transmission and RTTY operation.
Explains clarifier and split-frequency operation for advanced tuning.
Guides on VFO, memory storage, and programmable memory scan.
Demonstrates storing frequencies, recalling memories, and using VFO/memory transfers.
Classifies frequency bands into broadcast, military, RX only, and ham bands.
To Next Page
