To Next PageTo Next Page
Need help?Do you have a question about the Yaesu FT-7800R and is the answer not in the manual?
General| Mode | FM |
|---|---|
| Power Output | 50W (VHF), 35W (UHF) |
| Power Requirement | 13.8V DC |
| CTCSS/DCS | Yes |
| Antenna Impedance | 50 Ohms |
| Frequency Range | 144-148 MHz, 430-450 MHz |
| Dimensions | 140 x 40 x 180 mm |
| Weight | 1 kg |
Procedures for initial inspection and general recommendations for proper transceiver installation.
Essential safety precautions to follow when installing and operating the transceiver.
Guidelines and considerations for selecting and installing antennas for optimal transceiver performance.
Instructions for installing the transceiver in a vehicle, including mounting and power connections.
Steps for connecting the transceiver's DC power cable to the vehicle's battery terminals.
Guidance for setting up the transceiver for base station operation.
Procedure for powering the transceiver on and off using the PWR switch.
How to adjust volume and set the squelch sensitivity.
Methods for tuning frequencies using the dial, keypad, and scanning.
How to transmit using the PTT switch and normal voice levels.
Procedure for selecting different transmit power output levels.
How to lock or unlock keys and controls to prevent accidental changes.
How to set the RF squelch threshold based on S-meter level.
Information about repeater shift configurations and settings.
How to enable and use the ARS feature for automatic shift application.
Procedure for manually setting the repeater shift direction.
How to change the default repeater shift magnitudes for different regions.
How to set up and use CTCSS (Continuous Tone Coded Squelch System).
How to set up and use DCS (Digital Code Squelch) for access control.
How to scan for an unknown CTCSS or DCS tone being used.
How to configure the transceiver for split tone operation.
Procedures for storing, recalling, editing, and managing regular memory channels.
How to scan frequencies within the current VFO band.
How to scan through stored memory channels.
How to monitor a priority channel while operating on another frequency.
How to set up and activate the ARTS feature for range communication.
