Need help?Do you have a question about the Yaesu FTM-3207D and is the answer not in the manual?
General| Brand | Yaesu |
|---|---|
| Model | FTM-3207D |
| Category | Transceiver |
| Language | English |
Adjusts the microphone gain level for optimal audio input.
Configures the squelch to open only for signals above a set S-meter level.
Assigns functions to programmable microphone keys for quick access.
Configures split tone for repeaters using CTCSS and DCS control.
Scans for and identifies CTCSS tones used by other stations.
Scans for and identifies DCS codes used by other stations.
Utilizes paging and selective calling features with CTCSS tone pairs.
Stores receiving and transmitting CTCSS tone pairs for EPCS functionality.
Enables the EPCS system, indicated by a "P" on the display.
Covers DTMF tone generation and transmission via keypad or memory.
Manually transmits DTMF tones during transmission.
Stores DTMF codes into memory channels for later recall.
Transmits pre-registered DTMF codes using the Autodialer function.
Adjusts the speed at which DTMF digits are sent.
Sets the delay between keying the transmitter and sending the first DTMF digit.
Registers a separate transmit frequency to a memory channel with a receive frequency.
Transfers frequency data from a memory channel back to the VFO.
Disables VFO operation, allowing only memory channel selection.
Assigns an alphanumeric "Tag" or label to memory channels for easy identification.
Defines how the scanner behaves after stopping on a signal.
Masks specific memory channels to be skipped during scanning.
Sets up a "Preferential Scan List" of flagged channels to scan.
Scans frequencies between user-defined lower and upper band limits.
Initiates the Programmable Memory Scan operation.
Enables a beep when scanning reaches band edges or when tuning the VFO.
Periodically checks a defined memory channel for activity while operating on another channel.
Allows instant switching to the Priority Channel by pressing PTT.
Configures alert beeps for Group Monitor (GM) operation status.
Sets the interval for polling transmissions in Group Monitor mode.
Transfers memory and configuration data between transceivers.
Selects the Tone Encoder and/or Decoder mode (TONE, TSQL, DCS, PAGER).
Selects DCS inversion coding direction (NORMAL, INVERT, BOTH).
Sets the transmission mode (Manual, FMFIX, DNFIX, AUTO).
Assigns a function to the microphone [P3] key.
Selects the scanner resume mode (BUSY, HOLD, time-based).
To Next Page
