Yale Doorman L3 - Page 28

28
Changing the master code
• The master code is the
code you set when you first
started up the product after
installation. Do the following
to change the master code:
• Press
, enter the master
code, and press
again.
• Press 2
.
• Enter your new master code,
610 digits.
• Confirm by pressing
.
User code rejection in security
mode
• Press
, enter the master
code, and press
again.
• Press 9
.
• Press 1
.
• Press 1 to reject user codes in
security mode.
• Press 3 to accept user codes
in security mode.
• Confirm by pressing
.
Registering user codes
• Press
, enter the master
code, and press
again.
• Press 3
.
• Press 1
.
• Select a memory slot for the
user code: enter two digits
(0120) and press
.
• Enter the user code (length
must be identical to the
master code) and press
to confirm.
• Press * to register more user
codes or press
to exit.
Erasing user codes
• Press
, enter the master
code, and press
again.
• Press 3
.
• Press 3
.
• Select the user code
memory slot you want to
erase (0120) and press
to confirm.
Registering access control tags
• Press
, enter the master code,
and press
again.
• Press 4
.
• Press 1 to register a tag.
- Select a memory slot for the tag,
two digits (0120).
- Press
to confirm.
- Hold the tag to the reader and
wait for the sound.
• If you would like to use a four-
digit PIN with the tag, enter the
PIN and press
to confirm.
• If no PIN is required, press
.
• Press * to register more tags or
press
to exit.
If you have multiple locks, the tag
must be programmed on each lock. At
each lock, the tag must be read three
times after programming before it can
be used.
Erasing access control tags
• Press
, enter the master
code, and press
again.
• Press 4
.
• Press 3
to erase a tag.
- Select the tag memory
slot to erase, two digits
(0120).
- Press
to confirm.
If you have multiple locks, the
tag must be erased from each
lock.
Allow Doorman V2N access
control tags
• Press
, enter the master
code, and press
again.
• Press 9
.
• Press 2
.
• Press 1 to allow tags from the
older generation.
• Press 3 to block tags from the
older generation.
• Confirm by pressing
.