Yale Real Living YRMZB2

®
Yale Real Living™ ZigBee Module
Installation and Programming Instructions
®
Installing the ZigBee Module
It is recommended that lock is programmed through the centralized user interface (PC or
hand-held device) to ensure communication between the lock and the controller unit. The
network controller first needs to be in enrollment or exclusion mode for the lock to be
enrolled or unenrolled from network.
To Enroll the Module:
• Enter the 4-8 digit Master PIN code followed by the key.
• Press the key followed by the key.
• Press the key followed by the key.
To Unenroll the Module:
• Enter the 4-8 digit Master PIN code followed by the key.
• Press the key followed by the key.
• Press the key followed by the key.
Enrolling/Unenrolling the Network Module:
IMPORTANT: the batteries must be removed prior
to removing and/or inserting the network module:
• Remove battery cover.
• Remove batteries.
• Remove and/or insert network module.
• Reinstall batteries.
• Replace cover.
P/N AYR200-ZB-INSTAL-FUL Rev E

Yale Real Living YRMZB2 Specifications

General

Brand	Yale
Model	Real Living YRMZB2
Category	Control Unit
Language	English

Summary

Installing the ZigBee Module

Enrolling and Unenrolling the Network Module

Enroll the ZigBee Module

Steps to enroll the network module to the lock using Master PIN and specific key presses.

Unenroll the ZigBee Module

Steps to unenroll the network module from the lock using Master PIN and specific key presses.