Yale Conexis

Installing the Yale Access Module – Conexis
Installing the Module
Step 1. Remove battery cover
Using a Phillips-head screwdriver, loosen the battery cover screw. Slide the cover away from the lock.
Step 2. Remove a battery
Remove the batteries from your lock to power it off. Wait approximately 10 seconds for the lock to fully
power down.
Step 3. Remove the Module Cover
Slide the module cover up to remove this and access the slot

Yale Conexis Specifications

General

Brand	Yale
Model	Conexis
Category	Control Unit
Language	English

Summary

Installing the Yale Access Module

Remove Battery Cover

Loosen the battery cover screw and slide the cover away from the lock.

Remove Battery

Remove batteries to power off the lock and wait 10 seconds for full power down.

Remove Module Cover

Slide the module cover up to remove it and access the slot.

Install the Module

Insert the Yale Access module into the slot, ensuring it is properly seated.

Replace Battery Cover

Reinsert batteries; the lock light will flash blue and play a fanfare noise.

Register Module and Replace Cover

Follow the steps to register the Yale Access module with your lock.

Installing Yale Access Application

Download Yale Access App

Download the Yale Access App from the Apple Store or Google Play.

Set Up Device with QR Code or Serial Number

Use the QR code or serial number in the app to set up the device.

Set Up Yale Connect Wi-Fi Bridge

Follow the steps to set up the Yale Connect Wi-Fi bridge with your lock.

Setting Up Yale Connect Wi-Fi Bridge

Wi-Fi Bridge Requirements

Ensure Wi-Fi is on, connected to a 2.4 GHz network, and the phone is compatible.

Plug In and Connect Bridge

Plug the bridge into a socket, wait for the green light, and follow in-app instructions.