Yale SR-310

22
Adding & using devices
•
Key Fob
• Use the key fob to remotely arm, part arm or
disarm your alarm when within 30m range of
your Smart Hub.
• To add a Key Fob, see page 9.
• Pressing the panic button on the key fob will
immediately sound the alarm.
• To cancel the Panic alarm you will need to
enter your PIN code on your Key Pad.
Key Pad
Initialisation
IMPORTANT: If you purchase a Key Pad seperately to your
kit, you will need to initialise it before you learn it in for use
with your Smart Hub.
1 Press ‘Panic button A’ followed by factory
default Key Pad code ‘0000’.
2 The LED will now flash slowly indicating it is in
test (programming) mode.
3 Press ‘Panic button A’ followed by the ‘7’ key
to set the Key Pad into slave mode.
4 Quit test mode by pressing the disarm key
twice.
5 You are now ready to learn this in to your
system (see page 9).
/
Part Arm
Panic
ale
Y
1
2
3
6
5
4
7
8
9
0
Panic button A
Panic button B
Disarm
Home
Arm
LED
Learn button=
Press 8 and 9 together
/
Away
Part arm