Yale SR-310

28
Changing Batteries
•
Door/Window Contact Battery Change
When the battery is low the LED will light up when the door/window is opened.
Note: Door/Window Contact case tamper conditions are also indicated by a lit LED, check the tamper before
changing the battery.
CHANGE
BATTERY
2 x 1.5v AA
CR 2032
(22)
(GB) Changing batteries - (IT) Sostituzione batterie - (DE) Batteriewechsel - (NO) Batteribytte -
(SE) Batteribyte - (DK) Batteriskift.
CR 2032
3 x 1.5v AAA
SR-KP
SR-DC
SR-PC
SR-PIR / PETPIR
To change the battery:
1. Disarm 2. Unscrew
CHANGE
BATTERY
2 x 1.5v AA
CR 2032
(22)
(GB) Changing batteries - (IT) Sostituzione batterie - (DE) Batteriewechsel - (NO) Batteribytte -
(SE) Batteribyte - (DK) Batteriskift.
CR 2032
3 x 1.5v AAA
SR-KP
SR-DC
SR-PC
SR-PIR / PETPIR
5. Insert new
battery
6. Ret.3. Remove cap
top case.
4. Remove battery
CHANGE
BATTERY
2 x 1.5v AA
CR 2032
(22)
(GB) Changing batteries - (IT) Sostituzione batterie - (DE) Batteriewechsel - (NO) Batteribytte -
(SE) Batteribyte - (DK) Batteriskift.
CR 2032
3 x 1.5v AAA
SR-KP
SR-DC
SR-PC
SR-PIR / PETPIR
Please ensure battery
is inserted correctly.
CHANGE
BATTERY
2 x 1.5v AA
CR 2032
(22)
(GB) Changing batteries - (IT) Sostituzione batterie - (DE) Batteriewechsel - (NO) Batteribytte -
(SE) Batteribyte - (DK) Batteriskift.
CR 2032
3 x 1.5v AAA
SR-KP
SR-DC
SR-PC
SR-PIR / PETPIR
SR-PC
2.
Unscrew
& remove
top case
Alkaline
1. Disarm
3. Remove old & insert
new Batteries
4. Ret.
Please be careful
when removing case
as cable is very
delicate.
Alkaline
CHANGE
BATTERY
2 x 1.5v AA
CR 2032
(22)
(GB) Changing batteries - (IT) Sostituzione batterie - (DE) Batteriewechsel - (NO) Batteribytte -
(SE) Batteribyte - (DK) Batteriskift.
CR 2032
3 x 1.5v AAA
SR-KP
SR-DC
SR-PC
SR-PIR / PETPIR
EF-PIR
1. Disarm
2.
Unscrew
& remove
top case
3.
Remove
Batteries
3. Insert
new
Batteries
4. Ret.
PIR Battery Change
When the battery is low the LED will flash when any motion is detected. The batteries are changed as
follows:
Ensure tamper spring is fully
depressed when re-tting the PIR to
the back case. If this has not been
done correctly this will be indicated by a
ashing LED on the PIR.