To Next PageTo Next PageWhat to do if I cannot control mix parameters using MIDI Control Change messages on my Yamaha 03D?
If you cannot control mix parameters using MIDI Control Change messages, ensure that the 03D is configured to receive Control Change messages and that the MIDI Channels match. Also, check the parameter to Control Change assign table.
How to troubleshoot Yamaha Music Mixer monitor output if there is no input signal?
If input signals are present but the monitor output is dead, ensure that the MONITOR OUT SOLO/2TR IN switch is set to SOLO. Also, verify that the MONITOR OUT control is turned up, and that on the Moni.Setup page the MONI TRIM control is turned up and a monitor source is selected.
How to fix low input channel signal level on Yamaha 03D Music Mixer?
If the input channel signal level is very low, make sure that the GAIN control and PAD switch (channels 1 to 8) are set correctly. You can also use the Meter pages to check the levels.
What to do if I cannot recall mix scenes using MIDI Program Change messages on my Yamaha 03D?
If you're unable to recall mix scenes using MIDI Program Change messages, first ensure that the 03D is configured to receive Program Change messages and that the MIDI Channels match. Also, check the mix scene to Program Change assign table.
What to do if input signals are present but the display meters show nothing on my Yamaha 03D Music Mixer?
If input signals are present yet the display meters remain inactive, verify that the Meter mode isn't set to GAIN REDUCTION. This mode displays the amount of gain reduction applied by the dynamics processors.
What to do if my Yamaha Music Mixer 03D cannot be turned on?
First, ensure the power cord is securely connected to a suitable AC wall outlet. Next, check that the 03D POWER switch is in the ON position. If it still does not turn on, contact your Yamaha dealer.
What to do if I cannot recall effects programs 43, or 64 to Effect 1 on my Yamaha Music Mixer?
If you cannot recall effects programs 43, or 64 to Effect 1, note that these effects programs use the HQ. PITCH and FREEZE type effects, and can be recalled only to Effect 2.
What to do if signals appeared to be delayed on my Yamaha 03D Music Mixer?
General| Outputs | 8 |
|---|---|
| Sampling Rate | 44.1 kHz / 48 kHz |
| Bit Depth | 20-bit |
| Built-in Effects | Yes |
| EQ | 4-band parametric EQ per channel |
| MIDI | Yes |
| Control Surface | Yes |
| Type | Digital |
| Inputs | 16 |
| Effects Processors | 2 |
| Dynamic Processing | Compressor, Gate |
| Digital I/O | ADAT |
| Analog I/O | XLR/TRS combo |
| Power Supply | Internal |
