Operation
26
EMU27821
Stopping engine
Before stopping the engine, first let it cool off
for a few minutes at idle or low speed. Stop-
ping the engine immediately after operating at
high speed is not recommended.
EMU31521
Procedure
1. Push and hold the engine stop button un-
til the engine comes to a complete stop.
2. After stopping the engine, tighten the air
vent screw on the fuel tank cap and set
the fuel cock to the closed position.
IP:
The engine can also be stopped by pulling the
cord and removing the clip from the engine
shut-off switch.
EMU27862
Trimming outboard motor
WARNING
EWM00740
Excessive trim for the operating condi-
tions (either trim up or trim down) can
cause boat instability and can make steer-
ing the boat more difficult. This increases
the possibility of an accident. If the boat
begins to feel unstable or is hard to steer,
slow down and/or readjust the trim angle.
The trim angle of the outboard motor helps
determine the position of the bow of the boat
in the water. Correct trim angle will help im-
prove performance and fuel economy while
reducing strain on the engine. Correct trim an-
gle depends upon the combination of boat,
engine, and propeller. Correct trim is also af-
fected by variables such as the load in the
boat, sea conditions, and running speed.
U6A12RE0.book Page 26 Friday, February 27, 2009 10:26 AM
To Next Page
Loading...
