EasyManua.ls Logo

Yamaha 50C - User Manual

Yamaha 50C
114 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Printed in Japan
April 2003-0.5 × 1 !
63B-28199-1B
(40VETO, 50HETO)
(E)
Printed on recycled paper
40C
50C
OWNER’S MANUAL
U.S.A.Edition
LIT-18626-05-44
63B-9-1B-hyoshi 2/27/03 2:44 PM Page 1

Table of Contents

Questions and Answers

  • A
    Anna TaylorAug 20, 2025
    How to fix irregular idling or stalling in my Yamaha Outboard Motor?
    • E
      elopezAug 20, 2025
      If your Yamaha Outboard Motor idles irregularly or stalls, here's what you can check: * Inspect and replace fouled or incorrect spark plugs. * Check for obstructions in the fuel system. * Replace contaminated or stale fuel. * Clean or replace the fuel filter. * Make sure the air vent screw on the fuel tank is open, the choke knob is in home position, and the motor angle is at the normal operating position. * Also, ensure the fuel joint connection is correct and the battery lead is securely connected. If these steps don't resolve the issue, have a Yamaha dealer check the ignition parts, warning system, spark plug gap, ignition wiring, engine oil, thermostat, carburetor adjustments, or fuel pump.
  • B
    bjenningsAug 27, 2025
    How to troubleshoot a Yamaha Outboard Motor when the starter won't operate?
    • T
      Thomas BurkeAug 27, 2025
      If the starter on your Yamaha Outboard Motor won't operate, consider the following: * Check the battery condition and use a battery of the recommended capacity if it's weak or low. * Ensure battery connections are tight and clean any corrosion from the terminals. * Inspect the fuse for the electric start circuit and replace it with the correct amperage after addressing any electric overload. * Shift to neutral, in case the shift lever is in gear. For faulty starter components, have your Yamaha Outboard Motor serviced by a Yamaha dealer.
  • E
    ecallahanAug 30, 2025
    Why is my Yamaha 50C Outboard Motor vibrating so much?
    • S
      shawtonyaAug 31, 2025
      Excessive vibration in your Yamaha Outboard Motor can stem from several causes: * A damaged propeller should be repaired or replaced. * Remove any weeds or foreign matter tangled on the propeller. * Ensure the motor mounting bolts are tightened. For a damaged propeller shaft or loose/damaged steering pivot, it's best to have your Yamaha Outboard Motor serviced by a Yamaha dealer.
  • A
    Andrew FernandezNov 5, 2025
    Why won't my Yamaha Outboard Motor start, even though the starter is working?
    • M
      michelescottNov 5, 2025
      If your Yamaha Outboard Motor's starter operates but the engine doesn't start, several factors could be at play: * The fuel tank might be empty, requiring you to fill it with clean, fresh fuel. * The fuel could be contaminated or stale; in this case, replace it with clean, fresh fuel. * A clogged fuel filter could be the culprit, so clean or replace it. * The starting procedure might be incorrect; refer to the "STARTING ENGINE" section for guidance. * Other potential issues include fuel pump malfunctions, fouled or incorrect spark plugs, incorrectly fitted spark plug caps, poor ignition wiring, faulty ignition parts, a detached engine stop switch lanyard, or damaged engine inner parts. For issues beyond fuel, spark plugs, and wiring, consider having your Yamaha Outboard Motor se...
  • J
    Jacob ParksNov 10, 2025
    What does it mean when the warning buzzer sounds on my Yamaha 50C Outboard Motor?
    • B
      becky40Nov 10, 2025
      If the warning buzzer sounds or the indicator lamp lights on your Yamaha Outboard Motor, it indicates a potential issue. You can check the following: * Inspect the water intake for any restrictions that might be clogging the cooling system. * Ensure the engine oil level is adequate and fill the oil tank with the specified engine oil if it's low. * Verify that the spark plug has the correct heat range and replace it if necessary. * Confirm that you are using the specified engine oil and replace it if not. * If the engine oil is contaminated or deteriorated, replace it with a fresh, specified type. * Also, ensure that the load on the boat is properly distributed to maintain an even plane. For other potential problems, such as a clogged oil filter, malfunctioning oil feed/injecti...
  • K
    Kevin CuevasNov 15, 2025
    What to do if my Yamaha 50C is losing power?
    • D
      diane56Nov 15, 2025
      If your Yamaha Outboard Motor is experiencing power loss, several factors could be responsible: * Check for a damaged propeller and have it repaired or replaced. * Ensure the propeller pitch and diameter are correct for optimal speed. * Adjust the trim angle for efficient operation. * Verify the motor is mounted at the correct height on the transom. * Address any activated warning systems by identifying and correcting the cause. * Clean the boat bottom to remove marine growth. * Inspect, clean, or replace fouled or incorrect spark plugs. * Remove any weeds or foreign matter tangled on the gear housing. * Check for obstructions in the fuel system and clean or replace the fuel filter if clogged. * Replace contaminated or stale fuel with clean, fresh fuel. * Also, inspe...

Summary

General Information

Identification Numbers

Record outboard motor serial and key numbers for future reference.

Emission Control Information

Details on EPA regulations conformity for marine SI engines.

Safety Information

Crucial safety guidelines for operating the outboard motor.

Important Labels

Location and meaning of warning and caution labels on the motor.

Basic Boating Rules

International and USCG rules for navigation and vessel interaction.

Fueling Instructions

Safe procedures for handling gasoline and engine oil.

Battery Requirement

Specifications for electric start model battery capacity.

Propeller Selection

Guidance on choosing the correct propeller for performance.

Start-In-Gear Protection

Explanation of the safety feature preventing engine start in gear.

Basic Components

Main Components

Diagram and list of major outboard motor parts.

Fuel System

Components and function of the portable fuel tank system.

Control Operations

Using the remote control, shifter, throttle, and ignition.

Power Trim;Tilt Switch

Operation of the power trim and tilt switch.

Engine Stop Lanyard Switch

Function and safety features of the engine stop lanyard.

Instrumentation and Indicators

Explanation of the digital tachometer, meters, and warning lights.

Motor Adjustment Components

Operation of trim tab, tilt support lever, and cowling lock.

Operation

Installation

Guidelines for properly mounting the outboard motor on a boat.

Filling Fuel and Engine Oil

Procedures for refueling and adding engine oil.

Pre-Operation Checks

Essential checks before operating the outboard motor.

Operation After a Long Period of Storage

Steps to take when restarting an engine after extended storage.

Breaking In Engine

Procedure for the initial break-in period to ensure engine longevity.

Starting Engine

Step-by-step instructions for starting the outboard motor.

Warming Up Engine

How to properly warm up the engine before operation.

Shifting

How to engage forward and reverse gears safely.

Stopping Engine

Correct procedure for shutting down the engine.

Trimming Outboard Motor

How trim angle affects boat performance and handling.

Adjusting Trim Angle

Using the trim/tilt switch to set optimal motor angle.

Tilting Up;Down

Procedures for tilting the motor for shallow water or storage.

Cruising in Other Conditions

Advice for operating in salt or turbid water.

Maintenance

Specifications

Technical data and specifications for the outboard motor models.

Transporting and Storing Outboard Motor

Guidelines for safely trailering and storing the outboard motor.

Periodic Maintenance

Overview of routine maintenance tasks and schedules.

Maintenance Chart

Schedule of recommended maintenance checks and actions.

Engine & Fuel System Maintenance

Greasing, spark plugs, fuel system, filters, engine oil, fuses, wiring.

Drive Unit & External Care

Propeller, gear oil, battery, anodes, motor exterior, boat bottom maintenance.

Trouble Recovery

Troubleshooting

Common problems, possible causes, and remedies for engine issues.

Temporary Action in Emergency

Immediate steps for handling emergencies like impact or component failure.

Impact Damage

What to do if the outboard motor sustains impact damage.

Power Trim; Tilt Will Not Operate

Manual procedure if the power trim/tilt system fails.

Starter Will Not Operate

Using the emergency starter rope if the main starter fails.

Engine Fails to Operate

Steps for starting a cold engine that won't run.

Treatment of Submerged Motor

Immediate care for an outboard motor that has been submerged.

Index

Index

Alphabetical listing of topics and their page references.

Important Warranty Information for U.S.A. and Canada

Yamaha Outboard Motor Two Year Limited Warranty

Yamaha 50C Specifications

General IconGeneral
BrandYamaha
Model50C
CategoryOutboard Motor
LanguageEnglish

Related product manuals