Operation
24
2. Move the gear shift lever quickly and
firmly from neutral to forward.
Remote control models
1. Pull up the neutral interlock trigger (if
equipped) and move the remote control
lever quickly and firmly from neutral to
forward.
EMU27795
Reverse (manual tilt and hydro tilt
models)
WARNING
EWM00190
When operating in reverse, go slowly. Do
not open the throttle more than half. Oth-
erwise the boat could become unstable,
which could result in loss of control and
an accident.
Tiller control models
1. Place the throttle grip in the fully closed
position.
2. On models equipped with a tilt lock le-
ver, check that it is in the lock/down po-
sition.
3. Move the gear shift lever quickly and
firmly from neutral to reverse.
Remote control models
1. Check that the tilt lock lever is in the lock
position.
2. Pull up the neutral interlock trigger (if
equipped) and move the remote control
lever quickly and firmly from neutral to
reverse.
EMU27820
Stopping engine
Before stopping the engine, first let it cool off
for a few minutes at idle or low speed. Stop-
ping the engine immediately after operating
at high speed is not recommended.
EMU27832
Procedure
1. Push and hold the engine stop button
ZMU02030
N
F
ZMU02866
ZMU02030
ZMU02867
R
N
To Next Page
Loading...
Need help?
General
