Basic components
15
EMU26430
Carrying handle
A carrying handle is included on the clamp
bracket. After setting the handle up, it enables
you to carry the outboard motor easily with
one hand.
To set up the carrying handle, proceed as fol-
lows:
1. Place the tilt lock lever in the lock posi-
tion.
2. Securely hook the arm on the carrying
handle end to the clamp bracket bar.
CAUTION:
ECM00080
Place the tilt lock lever in the lock position
while using the carrying handle. Other-
wise, the lower unit could fall to the
ground while carrying the motor.
1. Top cowling lock lever(s)
1. Clamp bracket bar
U63V17E0.book Page 15 Thursday, February 26, 2004 11:52 AM
To Next Page
Loading...
