Operation
30
● Return the outboard motor to its normal
position as soon as the boat is back in
deeper water.
CAUTION:
ECM00260
Do not tilt the outboard motor up so that
the cooling water inlet on the lower unit is
above the surface of the water when set-
ting up for and cruising in shallow water.
Otherwise severe damage from overheat-
ing can result.
EMU28123
Procedure
1. Place the gear shift lever in neutral.
2. Place the tilt lock lever in the release/up
position.
3. Slightly tilt the outboard motor up. The tilt
support bar will lock automatically, sup-
porting the outboard motor in a partially
raised position.
NOTE:
This outboard motor has 2 positions for shal-
low water cruising.
4. To return the outboard motor to the nor-
mal running position, place the gear shift
lever in neutral, then place the tilt lock le-
ver in the lock/down position.
ZMU02868
U63V17E0.book Page 30 Thursday, February 26, 2004 11:52 AM
To Next Page
Loading...
