Yamaha DD-65 - Setting Click Volume

Play the Pads/Pedals
20
DD-65/YDD-60 Owner’s Manual
■ Setting the denominator of the time signature ...............................
Set the basic note value for each measure.
1 Enter the denominator value setting function.
2 Set the denominator value of the time signature.
3 Press the [FUNCTION] button to exit from the
Function mode.
■ Setting the click volume ....................................................................
Sets the click volume (range: 1–127).
1 Enter the click volume setting function.
2 Set the click volume by using the dial.
3 Press the [FUNCTION] button to exit from the
Function mode.
Press the [FUNCTION] button once, then press the [DRUM 1] or
[DRUM 2] button a number of times until the “CL2” item appears.
After a while, the current denominator value appears next to the
“CL2” indication.
Set the denominator value to one of the values 2 ( ), 4 ( ), 8 ( ), 16
() by using the DIAL.
• Default value is 4.
Press the [FUNCTION] button once, then press the [DRUM 1] or
[DRUM 2] button a number of times until the “CL3” item appears.
After a while current click volume will appear next to the “CL3” indi-
cation.
CL2
24816
NOTE
CL3
1 1272 126