Yamaha DT125R User Manual

6-35
PERIODIC MAINTENANCE AND MINOR REPAIR
6
EC000103
cC
Do not use a fuse of a higher
amperage rating than recommend-
ed to avoid causing extensive
damage to the electrical system
and possibly a fire.
3. Turn the key to “ON” and turn on
the electrical circuits to check if
the devices operate.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
EAU01307
Replacing the fuse
The fuse holder is located behind
panel B. (See page 6-8 for panel
removal and installation procedures.)
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to “OFF” and turn
off all electrical circuits.
2. Remove the blown fuse, and
then install a new fuse of the
specified amperage.
1
1. Fuse
EC000099
cC
If the breather hose is positioned
in such a way that the frame is
exposed to electrolyte or gas
expelled from the battery, the
frame could suffer structural and
external damages.
Specified fuse:
10 A
3MB-9-E8 6/13/01 10:55 AM Page 72

Yamaha DT125R Specifications

General

Displacement	124 cc
Fuel System	Carburetor
Ignition	CDI
Transmission	6-speed
Final Drive	Chain
Front Suspension	Telescopic fork
Front Brake	Single disc
Rear Brake	Single disc
Engine Type	Liquid cooled, 2-stroke, single cylinder
Rear Suspension	Monoshock
Fuel Capacity	10.5 L