Yamaha DT125R User Manual

6-39
PERIODIC MAINTENANCE AND MINOR REPAIR
6
EAU00898
Front wheel
To remove the front wheel
EW000122
w
8 It is advisable to have a
Yamaha dealer service the
wheel.
8 Securely support the motorcy-
cle so that there is no danger
of it falling over.
1. Remove the brake disc cover by
removing the screws.
1
2
2
1. Disc cover
2. Screw (×2)
To service the rear wheel
Raise the rear wheel off the ground
by using a motorcycle stand or, if a
motorcycle stand is not available, by
placing a jack either under each side
of the frame in front of the rear wheel
or under each side of the swingarm.
EAU01579
Supporting the motorcycle
Since this model is not equipped with
a centerstand, follow these precau-
tions when removing the front and
rear wheel or performing other main-
tenance requiring the motorcycle to
stand upright. Check that the motor-
cycle is in a stable and level position
before starting any maintenance. A
strong wooden box can be placed
under the engine for added stability.
To service the front wheel
1. Stabilize the rear of the motorcy-
cle by using a motorcycle stand
or, if an additional motorcycle
stand is not available, by placing
a jack under the frame in front of
the rear wheel.
2. Raise the front wheel off the
ground by using a motorcycle
stand.
3MB-9-E8 6/13/01 10:55 AM Page 76

Yamaha DT125R Specifications

General

Displacement	124 cc
Fuel System	Carburetor
Ignition	CDI
Transmission	6-speed
Final Drive	Chain
Front Suspension	Telescopic fork
Front Brake	Single disc
Rear Brake	Single disc
Engine Type	Liquid cooled, 2-stroke, single cylinder
Rear Suspension	Monoshock
Fuel Capacity	10.5 L