Manual Development Group
©2016 Yamaha Corporation
Published 07/2016 YJ-A0
DTX900M/DTX900/DTXTREME III Firmware Update Guide 5
■The Version History provided hereafter is for the
DTXTREME III.
【V1.01 → V1.03】
・ Added new Trigger Setups which are compatible with the new pads (XP series.)
・ Added new Pad Type Settings which are compatible with the new pads (XP series.)
・ Added the Cubase Remote Control function.
NOTE
In order to use the Cubase Remote Control function, you will need to purchase Cubase 5 or later.
・ Added BYPASS indications for the Variation, Reverb and Chorus Effect in the Drum Kit Select display
which lets you turn the Effect Bypass on/off.
・ Added the new parameter “phones” into the OutputSel settings in the display called up via [DRUMKIT]
---> [F2] VOICE ---> [SF2] OUT-TUNE.
・ Added the new parameter “TrigSetupLink” in the display called up via [DRUMKIT] ---> [F5] OTHER --
-> [SF1] COMMON.
・ Added the new parameter “IndivOutAssign” in the display called up via [UTILITY] ---> [F1] GENERAL
---> [SF5] OTHER.
・ Solved other minor problems.
【V1.01 → V1.02】
・ Improved the performance in which sound was previously cut off when many User Voices were played
simultaneously.
・ MIDI messages generated by choking and muting of the cymbal pad can be recorded to the song, as
well as being transmitted or received.
・ Now supports the specification change for the USB storage devices of some manufacturers.
・ Solved other minor problems.
To Previous Page
Loading...
