What to do if MIDI data cannot be exchanged with a computer or external MIDI device on Yamaha Drums?
If you're having trouble exchanging MIDI data with a computer or external MIDI device on your Yamaha Drums, consider the following: If using USB cables, ensure they are connected correctly. Also, verify that the MIDI IN/OUT parameter is set to 'USB' or 'MIDI' as appropriate.
Why do my Yamaha DTX-Multi 12 Drums sounds not stop or sound distorted?
If the sounds on your Yamaha Drums don't stop, are distorted, or are intermittent and stuttered, ensure that the setting for the M.Tune parameter is not too far removed from '0'.
What to do if multiple sounds are produced when a single pad is struck on Yamaha DTX-Multi 12 Drums?
If multiple sounds are produced when you strike a single pad on your Yamaha Drums, ensure that the signal cable is securely plugged into the jack on the DT20 or other drum trigger.
How to prevent double triggers on Yamaha DTX-Multi 12 Drums?
If multiple sounds are produced by a struck pad (double triggers) on your Yamaha Drums, and your external pads and triggers have output or sensitivity controllers, reduce the output or sensitivity to a more appropriate level.
Why can't I play closed hi-hat sounds on my Yamaha DTX-Multi 12 Drums?
If you cannot play closed hi-hat sounds on your Yamaha Drums, ensure that a suitable type has been selected for the pad type.
How to fix Yamaha DTX-Multi 12 when no sound is produced?
If your Yamaha Drums aren't producing sound, or the volume is lower than expected, try these solutions: * Make sure the LocalCtrl parameter is set to 'on'. * Check that all layers are not turned off. * Verify headphones or external audio system (amplifier and speakers) are correctly connected. * Ensure the cables are in good condition. * Confirm the Func parameter is set to 'off'. * Check that the Pad10-12 parameter is set to 'enable'. * Adjust the Volume dial on the front panel correctly. * Set the Voice Volume page for each pad's voices correctly. * Correctly set the Master Volume page for the instrument. * Ensure MIDI cables are connected correctly. * Set the correct interface for sending MIDI data. * Confirm the DTX-MULTI 12 sends data on the MIDI channel the ...
General| Number of pads | 12 |
|---|---|
| Tempo range | 30 - 300 bpm |
| Sound effects | Chorus, Reverberation |
| Drum sound types | Percussion |
| Drum kits quantity | 50 |
| Maximum note storage | 152000 |
| Sample audio formats | AIFF, WAV |
| User presets quantity | 200 |
| Preset rhythm patterns | 128 |
| Sound effects quantity | 3 |
| Maximum polyphony (notes) | 64 |
| Reverberation effects quantity | 6 |
| Display type | LCD |
| Built-in display | Yes |
| Display number of characters | 16 |
| XLR out | 13 |
| USB connector type | USB Type-A, USB Type-B |
| USB ports quantity | 2 |
| Power source type | AC |
| Power consumption (typical) | 9 W |
Weight and Dimensions| Depth | 319 mm |
|---|---|
| Width | 345 mm |
| Height | 96 mm |
| Weight | 3300 g |
To Next Page
