Why Yamaha E8DMH Outboard Motor gauge operates unstably?
If the gauge operates unstably, it could be because a resistor is not connected to the ending hubs. Connect the gray 6-pin cap to the ending multi-hubs.
How to fix Yamaha Outboard Motor trim gauge showing incorrect position?
If the trim gauge shows an incorrect position, the initial position setting might be wrong, or the trim sender could be damaged. Put the motor in the fully trimmed-in position and reset the initial (zero) trim angle. If that doesn't work, replace the trim sender.
Why Yamaha Outboard Motor Speedometer or Comb. Speedometer & Fuel mgt gauge shows incorrect fuel level?
If the speedometer or combination speedometer & fuel management gauge shows an incorrect fuel level, the fuel sensor selection is likely wrong. Set up the fuel sensor to the correct resistance.
What to do if Yamaha E8DMH Outboard Motor gauge shows “----”?
If the gauge displays '----', it indicates that the digital signal is not being received. Check that the couplers are securely connected and replace any damaged bus wires or hubs.
What causes Yamaha Outboard Motor fuel management gauge to show incorrect remaining fuel?
If the fuel management gauge shows incorrect remaining fuel, the fuel capacity setting may be wrong (specifically for SQR Fuel mgt Gauge). Fill the tank with fuel, and set the correct fuel tank capacity.
How to fix Yamaha E8DMH Outboard Motor tachometer showing incorrect engine RPM?
If the tachometer shows an incorrect engine RPM, the engine recognition might be wrong (especially for multi-applications). To correct this, push the 'SET' button for 10 seconds to default the engine number, then memorize each engine number again.
Why Yamaha Outboard Motor illumination does not light?
If the illumination does not light, it could be due to a lack of electrical power or a damaged gauge. You should try replacing the fuse, connecting the couplers securely, replacing the damaged wire or hub, or replacing the gauge.
What to do if Yamaha E8DMH fuel management gauge shows incorrect fuel consumption?
If the fuel management gauge shows incorrect fuel consumption, the engine recognition might be wrong (especially for multi-applications). To fix this, default the engine number and turn the key switch on in order from the portside engine to re-memorize each engine number.
What does it mean when my Yamaha E8DMH Outboard Motor gauge shows “----”?
General| Brand | Yamaha |
|---|---|
| Model | E8DMH |
| Category | Outboard Motor |
| Language | English |
Step-by-step procedure for safely removing the outboard motor from its steel crate.
Instructions for correctly mounting the outboard motor onto the boat transom, including height adjustments.
Guidance on selecting propellers based on operating load, boat type, and engine speed at WOT.
Overview of throttle control systems (Push To Open/Pull To Open) and connector types.
Details on the fuel management gauge, its functions, applications, dimensions, and setup.
Representative wiring diagram samples for Yamaha remote controls and instruments.
Table listing common troubleshooting symptoms, causes, measures, and notes for digital gauges.
Wiring diagrams for dual station applications with 6Y9 gauges.
To Next Page
