What to do if the bass phrase of the Auto Bass Cord cannot be heard on my Yamaha Musical Instrument?
If you cannot hear the bass phrase of the Auto Bass Chord on your Yamaha Musical Instrument, the pedal polyphonic mode may be on. Turn it off in the Voice Condition display.
What to do if the sound is too small on my Yamaha Musical Instrument even when the volume is at maximum?
If the sound from your Yamaha Musical Instrument is too quiet even at maximum volume: * Ensure the Master Volume isn't set too low by turning it clockwise. * Check that the Expression Pedal is fully pressed down. * Verify the speaker's POWER switch is on. * (For ELS-01C/01X models) Confirm the REAR SPEAKER switch is set to ON.
What to do if my Yamaha Musical Instrument panel does not function normally?
If your Yamaha Musical Instrument panel malfunctions or memorized data changes, this may be due to power surges or spikes. Perform the Factory Set operation to reset the Electone.
What to do if I am recording and it is stopped before the performance is finished on my Yamaha Musical Instrument?
If recording stops prematurely on your Yamaha Musical Instrument: * The storage media may be full. Use another media or delete unnecessary songs. * When overwriting, the new recording cannot exceed the length of the previous one. Delete the old recording and re-record.
What to do if I hear a cracking noise from my Yamaha Musical Instrument?
Cracking noises from your Yamaha Musical Instrument may occur when electrical appliances or power tools are used nearby. Plug the Electone into an outlet as far from the interfering device as possible.
Why does the pitch in the Single Finger mode not change on my Yamaha Musical Instrument?
In Single Finger mode on your Yamaha Musical Instrument, notes are produced only within a fixed octave interval on the Lower keyboard. Pressing keys with the same letter name outside this range will result in chords with the same pitch.
What causes interference from radio or TV on my Yamaha Musical Instrument?
This is caused by the proximity of a high-power broadcasting station, an amateur ham radio setup or a mobile phone.
Why does even though a User button’s rhythm has been selected and started, the pattern does not sound on my Yamaha Musical Instrument?
No rhythm will sound if a pattern has not been saved to the selected User button on your Yamaha Musical Instrument, as the User buttons contain User rhythms.
What to do if the harmony notes of the Melody On Chord function cannot be heard on my Yamaha Musical Instrument?
If you can't hear the harmony notes of the Melody On Chord function on your Yamaha Musical Instrument, the Upper keyboard may be set to sound only Lead Voices. Increase the volume of the Upper Keyboard Voices.
What to do if the Reverb effect is not applied to the desired Voice sections on my Yamaha Musical Instrument?
If the Reverb effect isn't applying to specific Voice sections on your Yamaha Musical Instrument, increase the Reverb depth for those sections in Reverb Display Pages 2 – 4.
General| Number of Keys | 61 |
|---|---|
| Sound Generation | AWM (Advanced Wave Memory) |
| Power Supply | AC adapter |
| Polyphony | 128 notes |
| Effects | Reverb, Chorus, DSP |
| Display | LCD |
| Connectivity | USB, MIDI, Audio In/Out |
| Touch Sensitivity | Yes |
| Registration Memory | Yes |
| Voices | 1, 000 voices |
| Speakers | 2 x 5 cm tweeters |
To Next Page
