Specifications and requirements
19
boat does not have a capacity plate, consult
the boat manufacturer.
EMU40491
Mounting outboard motor
EWM02501
Improper mounting of the outboard mo-
tor could result in hazardous condi-
tions such as poor handling, loss of
control, or fire hazards.
Because the outboard motor is very
heavy, special equipment and training
is required to mount it safely.
Your dealer or other person experienced in
proper rigging should mount the outboard
motor using correct equipment and complete
rigging instructions. For further information,
see page 57.
EMU38582
Yamaha Security System (if
equipped)
ECM02461
The Yamaha Security System is sold in
conformity with the relevant laws and
regulations regarding radio wave trans-
mission. Therefore, if this product is used
outside the country where it was sold, it
may violate the laws or regulations re-
garding radio wave transmission in the
country it is used in. For details, consult
your Yamaha dealer.
This outboard motor is equipped with the
Yamaha Security System to protect against
theft, which consists of the receiver and re-
mote control transmitter. The engine can not
be started if the security system is in the lock
mode, and only be started in the unlock
mode. Consult your Yamaha dealer for in-
stallation of the receiver.
EMU34954
Digital electronic control
requirements
The digital electronic control is equipped with
a start-in-gear protection device(s). This de-
vice prevents the engine from starting unless
it is in neutral.
EWM01581
If the engine starts in gear, the boat can
move suddenly and unexpectedly, pos-
sibly causing a collision or throwing
passengers overboard.
If the engine ever starts in gear, the
start-in-gear protection device is not
working correctly and you should dis-
continue using the outboard. Contact
your Yamaha dealer.
This digital electronic control unit is only
available for the outboard motor which you
have purchased.
Prior to use of the digital electronic control
unit, set it in order to operate your outboard
motor only. Otherwise, it will not be possible
to operate the outboard motor.
Perform setting of the outboard motor and
the digital electronic control unit in the follow-
ing cases.
If a used outboard motor is installed
If the digital electronic control unit is re-
6CE-9-36-1E0.book 19 ページ ２０１４年１１月２８日 金曜日 午後２時５５分
©2019 Yamaha Motor Corporation, U.S.A.
To Next Page
Loading...
Need help?
General
