4-21
E
EMU00992
CHECKING POWER TRIM AND TILT
SYSTEM
w
8 Never get under the lower unit while it
is tilted, even when the tilt-support
lever is locked. Severe injury could
occur if the outboard accidentally falls.
8 Make sure no one is under the out-
board before performing this test.
1) Check the power trim and tilt unit for
any sign of oil leaks.
2) Operate each of the power trim and
tilt switches on remote control and
engine bottom cowling (If equipped)
to check that all switches work.
3) Tilt up the motor and check that the
trim and tilt rod 1 is pushed out com-
pletely.
4) Check that the trim and tilt rod is free
of corrosion or other flaws.
5) Operate the motor to trim and tilt
down. Check that the trim and tilt rod
operates smoothly.
NOTE:
If any operation is abnormal, consult a
Yamaha dealer.
Recommended fluid;
Yamaha power trim & tilt fluid or ATF
(DEX
67C-9-12-4 5/1/01 5:27 PM Page 22
To Next Page
Loading...
Need help?
General
