Need help?Do you have a question about the Yamaha GYTR YZF-R6 2022 and is the answer not in the manual?
General| Displacement | 599cc |
|---|---|
| Bore x Stroke | 67.0 mm x 42.5 mm |
| Compression Ratio | 13.1:1 |
| Fuel System | Fuel Injection |
| Transmission | 6-speed |
| Final Drive | Chain |
| Front Tire | 120/70ZR17 |
| Rear Tire | 180/55ZR17 |
| Engine Type | Liquid-cooled, 4-stroke, DOHC, 4-valve |
| Ignition | TCI |
| Front Suspension | fully adjustable |
| Rear Suspension | fully adjustable |
| Front Brake | Dual 320mm discs |
| Rear Brake | 220mm disc |
Information regarding warranty coverage for the kit parts.
Guidelines and requests for using the kit parts exclusively for racing.
Explanation of symbols used in the parts list, such as star and circle marks.
Explanation of safety alert symbols like WARNING, NOTICE, and TIP.
Details about the electric components included in the kit.
Explains names and functions of handlebar switches for operation.
Details about different ECU sets and their specifications for racing.
Information about the cable interface for connecting to a PC for system setup.
Details about the Communication Control Unit (CCU) and its components.
Contains various gaskets and seals for engine maintenance and assembly.
Details about semi surface discharge and angled ground strap spark plugs.
Lists different thickness head gaskets for adjusting compression ratio.
Piston set details, including weight selection guidelines for performance.
Connecting rod set information, emphasizing weight uniformity for balance.
Crankshaft part details, recommending selection for good balance.
Details on intake and exhaust cam shafts and sprockets for timing adjustment.
Valve spring set for improving engine performance and durability with kit camshafts.
Oil pump assembly with higher discharge capability than standard.
Throttle body clamp assembly for enhancing maintenance and preventing over-tightening.
Air funnel set for SS specification, detailing installation steps.
Air funnel set for STK specification, detailing installation.
Plug set for use when the AIS system is removed.
Clutch spring set with higher mounting load than standard.
Friction plate set enhancing durability and operation compared to standard.
Slipper clutch setting set for back torque limiter adjustment.
Oil catch tank set to manage crankcase emissions.
Rear shock springs with different rates and identification stamps.
Front fork springs with identifying slits for rate identification.
Anti-slip seat cushion that can be cut to size.
Front spare wheel assembly including bearings, spacers, and sensor.
Rear spare wheel assembly with bearings, brake disk, and sensor.
Throttle tube guide specification and installation instructions.
Step-by-step instructions for tightening cylinder head bolts in sequence.
Detailed instructions for tightening crankcase bolts with specific sequences and angles.
To Next Page