30
Function and operation of components
4. When the timer is activated a notification
window will appear approximately 10
minutes prior to the system being pow-
ered down.
■ System Info
This function is to show information on the
Helm Master control system components
mounted on the boat and the software ver-
sion of the Digital Network gauge (6Y9).
■ Trim Assist
This function automatically sets the outboard
motor trim angle according to the engine
speed.
1. From the main menu, select “Trim
Assist”.
• There are no default trim assist positions
set in a new gauge. The trim assist posi-
tion settings must be made in order for the
trim assist to function.
• Lower the engines to the trim range before
starting. Trim assist will not lower the
engines until shifted into gear.
0KAW_dtp_data_US.book Page 30 Monday, December 17, 2012 3:35 PM
To Next Page
Loading...