Yamaha Helm Master - Current

33
Function and operation of components
4. Push the joystick switch again to com-
plete the setting for STBD.
TIP:
If the joystick switch is pressed while the joy-
stick is in the N position, all calibrated set-
tings for the joystick will return to default.
5. While not in the joystick mode, push and
hold the joystick switch for 5 seconds to
enter the calibration mode.
6. Move the joystick to PORT. Rotate the
joystick until the boat moves directly to
PORT.
7. Push the joystick switch again to com-
plete the sertting for PORT.
TIP:
If the joystick switch is pressed while the joy-
stick is in the N position, all calibrated set-
tings for the joystick will return to default.
■ Current
“STEERING MALFUNCTION” and “CHECK
SYSTEM” warnings are provided. See page
27 for further information.
0KAW_dtp_data_US.book Page 33 Monday, December 17, 2012 3:35 PM