Yamaha HTR-5071 Firmware Update Procedure

RX-V583
1
Choose from the following 2 methods to update to the latest firmware.
IMPORTANT NOTICE
Do not attempt to update your Yamaha receiver using any other data file except those provided directly from the
Yamaha website or through your network connection.
Follow the instructions carefully and do not attempt any other procedures not specified in the instructions provided by
Yamaha.
Improperly updated products may cause improper operation, and any parts or service required to restore proper
operation will not be covered under the Yamaha Limited Warranty.
FIRMWARE UPDATING PROCEDURE
Click here for
Firmware Update Through the Internet
(Connection to the Internet is required)
Click here for
Firmware Update by USB
(A USB thumb drive is required)
In case of error, see the
Troubleshooting
section

Yamaha HTR-5071 Specifications

General

Type	Stereo Receiver
Power Output	100 W
Frequency Response	10 Hz - 100 kHz
Total Harmonic Distortion	0.06%
HDMI Inputs	4
HDMI Outputs	1
4K Ultra HD Pass-through	Yes
HDR Support	Yes
Dolby Atmos	No
DTS:X	No
Wi-Fi	No
Bluetooth	No
AirPlay	No
Phono Input	Yes
Zone 2 Audio Output	No
Signal-to-Noise Ratio	100 dB
Power output per channel	100 W
Power Output (6 ohms)	100W
Inputs	HDMI, Digital Optical
Outputs	HDMI, Subwoofer
Input Sensitivity/Impedance	200 mV/47 kΩ
Speaker Impedance	6 ohms