Operation
67
make sure that the digital electronic con-
trol-active indicator lights. The engine
can not be started when the digital elec-
tronic control-alert indicator lights.
5. Turn the main switch to “ ” (start),
and hold it for a maximum of 5 seconds.
NOTICE: Never turn the main switch
to “ ” (start) while the engine is
running. Do not keep the starter mo-
tor turning for more than 5 seconds. If
the starter motor is turned continu-
ously for more than 5 seconds, the
battery will be quickly discharged,
thus making it impossible to start the
engine. The starter can also be dam-
aged. If the engine will not start after
5 seconds of cranking, return the
main switch to “ ” (on), wait 10 sec-
onds, then crank the engine again.
[ECM00193]
When starting the engine using the
Start/Stop button, press the button to
start the engine. The indicator for the
starting engine will come on.
When starting the engine using the
Start/Stop button on the All Start/Stop
switch panel, press the button to start
the all engines.
When the main switch is turned to “ ”
(start) with the clip removed from the en-
gine shut-off switch, the buzzer will sound.
For twin type, if the clip is removed from
the engine shut-off switch, the buzzer will
sound when the Start/Stop button is
pressed.
For twin type, when either engine has
started, the engine that has started can be
stopped by pressing the Start/Stop button
on the All Start/Stop switch panel.
6CE-9-36-1E0.book 67 ページ ２０１４年１１月２８日 金曜日 午後２時５５分
©2019 Yamaha Motor Corporation, U.S.A.
To Next Page
Loading...
