3-14
NOTE: Before the first start-up, re-
move the fuel tank filler cap to release
any built-up pressure in the tank
because of fuel expansion.
3) Attach the lanyard clip to your PFD.
Install the lanyard lock plate on the
engine stop switch by pushing the
lock plate groove over the nut
beneath the knob. Be sure the lan-
yard is not wrapped around the
steering wheel or tangled in the con-
trols.
➀ Engine stop switch
➁ Lock-plate with lanyard
NOTE: It is not possible to start the
engine with the lock-plate removed
from the engine stop switch. However,
the starter motor will turn the engine
over.
4) Pull the choke knob all the way out.
NOTE:
● It may be necessary to hold the
choke knob completely pulled out
when starting a very cold engine.
● After the engine has warmed up,
push the choke knob in gradually.
The choke should not be used when
the engine is warm.
1
2
3 OPERATION
To Next Page
Loading...
