3-13
OPERATION
STARTING THE ENGINES
SEVERE INJURY OR DEATH MAY
RESULT IF YOU IGNORE ANY OF
THE FOLLOWING:
● Before operating your Jet Boat,
become familiar with all controls.
Consult your Yamaha dealer
about any control or function you
do not fully understand.
● Attach the engine stop switch
lanyard to your personal flotation
device before operating. Failure
to attach lanyard could result in a
runaway boat if operator is
ejected.
● Check throttle, steering and shift
lever for proper operation before
starting the engine.
● Shift into neutral before starting
engines. Put throttle levers in idle
position before shifting.
1) Always make sure the boat is
launched and used in waters that
are free from weeds and debris, and
at least 3 ft (90 cm) deep.
Never operate in water that is less
than 3 ft (90 cm) deep. You increase
your chance of hitting an underwa-
ter obstacle. You could be injured.
Pebbles or sand can also be sucked
into the jet (water) intake, damaging
the impeller.
There is a hull drain plug at the bot-
tom of the stern in the center. Be
sure it is securely tightened before
launching the Jet Boat.
2) Turn the fuel cock knobs to the "ON"
position.
To Next Page
Loading...
