Yamaha MC1608M - Page 6

75
—
a
@ AUX IN Assign switches
Pressing an AUX IN assign switch will send the auxiliary input signal to the correspondingly
numbered output buss.
In the case of an echo unit connected to the auxiliary input, this would allow any or all of the
players to have echo in their monitor mix. е
AUX IN level control”
This control is used to set the level of the signals received at the auxiliary inputs. Nominal level
is obtained with the control set at 8.
Again, this is useful if the auxiliary inputs are used for echo or signal processing, when it will
function as a "return" and provide exact matching with of output level the effects unit you are
using.
AUX CUE switch
Depressing the auxiliary CUE button mutes all master CUE signals in the headphones,
permitting the engineer's checking of only the selected auxiliary signal, regardless of whether a
master CUE switch is on or off. Please note that as with the input channel cue switches,
engaging an AUX in cue switch will cause the input CUE indicator to light. This switch can be
used whether the AUX in switch is on or off.
AUX In ON switch
This switch, like the input channel ON switch, provides an instant means for turning the
auxiliary input on or off. It is ON in the DOWN position.
MASTER CUE
4
o
ш Of
- (M m stu QM 5
ЕВЕ 268
ыышышышы „кб
ОсоооОоОСбоххоаш
4адчЧа л аччлЫб5эЭВЗэ
БЕ БАа-оьо
tV
AUX IN | AUX IN | ON
AUX IN | Ж “о
(+4dB)
^ {AUX IN 2
AUX IN2 | Вэ o "o
(+4dB) |
т ч AUXIN 2 CUE)
Ө / 80 (high pass fiiter) switch
Depressing this switch inserts a filter on the master output below 80Hz, with a roll-off of 18
dB/octave. Monitor speakers are often compact and unable to handle low frequencies at high
levels. This filter will enable you to roll-off the low end and raise the overall monitor level, as
- well as reducing wind noise, microphone "popping", and АС mains hum.
НЕА LUE 14141111
ШИШ! 111: T]
AE у HIA
|2
RESPONSE(dB)
-10
I | Шири ч
21111131 (15 |