Yamaha MOTIF ES6 - Page 30

VINTAGE FLANGER 1 – 3
TEMPO FLANGER
DYNAMIC FLANGER
PHASER1
PHASER2
VINTAGE STEREO PHASER 1 – 2
The Color parameter is not available when the Mode = 1 and the Stage = 4, 6, 8, or the Mode = 2 and
the Stage = 4, 10.
VINTAGE MONO PHASER 1 – 2
The Color parameter is not available when the Mode = 1 and the Stage = 4, 6, 8, 12, 16, or the Mode =
2 and the Stage = 4, 10.
TEMPO PHASER
DYNAMIC PHASER
TREMOLO
No. Parameter Range Value Table No.
01 Speed 0.040Hz – 10.00Hz (0 – 235) 22
02 Manual 0 – 127 (0 – 127)
03 Depth 0 – 127 (0 – 127)
04 Feedback 0 – 127 (0 – 127)
05 Type 1 – 3 (0 – 2)
06 Spread 0 – 127 (0 – 127)
07 Mix 0 – 127 (0 – 127)
13 EQ Low Frequency 32Hz – 2.0kHz (4 – 40) 3
14 EQ Low Gain -12dB – +12dB (52 – 76)
15 EQ High Frequency 500Hz – 16.0kHz (28 – 58) 3
16 EQ High Gain -12dB – +12dB (52 – 76)
No. Parameter Range Value Table No.
01 LFO Speed 16th – 4thx8 (5 – 21) 14
02 LFO Depth 0 – 127 (0 – 127)
03 Feedback Level -63 – +63 (1 – 127)
04 Delay Offset 0.0ms – 50.0ms (0 – 127) 2
05 LFO Phase Reset off (free run), KeyOnReset,
SEQ Start Reset
(0 – 2)
06 EQ Low Frequency 32Hz – 2.0kHz (4 – 40) 3
07 EQ Low Gain -12dB – +12dB (52 – 76)
08 EQ High Frequency 500Hz – 16.0kHz (28 – 58) 3
09 EQ High Gain -12dB – +12dB (52 – 76)
10 Dry / Wet Balance D63>W – D=W – D<W63 (1 – 127)
11 EQ Mid Frequency 100Hz – 10.0kHz (14 – 54) 3
12 EQ Mid Gain -12dB – +12dB (52 – 76)
13 EQ Mid Width 0.1 – 12.0 (1 – 120)
14 LFO Phase Difference -180deg – +180deg (4 – 124)
No. Parameter Range Value Table No.
01 Sensitivity 0 – 127 (0 – 127)
02 Delay Time Offset 0 – 127 (0 – 127)
03 Feedback Level -63 – +63 (1 – 127)
04 Attack Time 0.3ms – 227ms (0 – 127) 17
05 Release Time 2.6ms – 2171ms (0 – 127) 18
06 Release Curve 0 – 127 (0 – 127)
07 Direction up, down (0 – 1)
08 Dyna Threshold Level 0 – 127 (0 – 127)
09 Dyna Level Offset 0 – 127 (0 – 127)
10 Dry / Wet Balance D63>W – D=W – D<W63 (1 – 127)
13 EQ Low Frequency 32Hz – 2.0kHz (4 – 40) 3
14 EQ Low Gain -12dB – +12dB (52 – 76)
15 EQ High Frequency 500Hz – 16.0kHz (28 – 58) 3
16 EQ High Gain -12dB – +12dB (52 – 76)
No. Parameter Range Value Table No.
01 LFO Speed 0.0Hz – 39.70Hz (0 – 127) 1
02 LFO Depth 0 – 127 (0 – 127)
03 Phase Shift Offset 0 – 127 (0 – 127)
04 Feedback Level -63 – +63 (1 – 127)
06 – 09: Same as marked with *.
10 Dry / Wet Balance D63>W – D=W – D<W63 (1 – 127)
11 Stage 4 – 22 (4 – 22)
12 Diffusion mono/stereo (0 – 1)
No. Parameter Range Value Table No.
01 LFO Speed 0.0Hz – 39.70Hz (0 – 127) 1
02 LFO Depth 0 – 127 (0 – 127)
03 Phase Shift Offset 0 – 127 (0 – 127)
04 Feedback Level -63 – +63 (1 – 127)
06 – 09: Same as marked with *.
10 Dry / Wet Balance D63>W – D=W – D<W63 (1 – 127)
11 Stage 3 – 11 (3 – 11)
13 LFO Phase Difference -180deg – +180deg (4 – 124)
No. Parameter Range Value Table No.
01 Speed 0.100Hz – 10.00Hz (0 – 252) 23
02 Manual 0 – 127 (0 – 127)
03 Depth 0 – 127 (0 – 127)
04 Feedback 0 – 127 (0 – 127)
05 Stage 4, 6, 8, 10 (0 – 3)
06 Mode 1, 2 (0 – 1)
07 Color 0 – 127 (0 – 127)
08 Spread 0 – 127 (0 – 127)
No. Parameter Range Value Table No.
01 Speed 0.100Hz – 10.00Hz (0 – 252) 23
02 Manual 0 – 127 (0 – 127)
03 Depth 0 – 127 (0 – 127)
04 Feedback 0 – 127 (0 – 127)
05 Stage 4, 6, 8, 10, 12, 16 (0 – 5)
06 Mode 1, 2 (0 – 1)
07 Color 0 – 127 (0 – 127)
13 EQ Low Frequency 32Hz – 2.0kHz (4 – 40) 3
14 EQ Low Gain -12dB – +12dB (52 – 76)
15 EQ High Frequency 500Hz – 16.0kHz (28 – 58) 3
16 EQ High Gain -12dB – +12dB (52 – 76)
No. Parameter Range Value Table No.
01 LFO Speed 16th – 4thx8 (5 – 21) 14
02 LFO Depth 0 – 127 (0 – 127)
03 Phase Shift Offset 0 – 127 (0 – 127)
04 Feedback Level -63 – +63 (1 – 127)
05 LFO Phase Reset off (free run), KeyOnReset,
SEQ Start Reset
(0 – 2)
06 EQ Low Frequency 32Hz – 2.0kHz (4 – 40) 3
07 EQ Low Gain -12dB – +12dB (52 – 76)
08 EQ High Frequency 500Hz – 16.0kHz (28 – 58) 3
09 EQ High Gain -12dB – +12dB (52 – 76)
10 Dry / Wet Balance D63>W – D=W – D<W63 (1 – 127)
11 Stage 3 – 11 (3 – 11)
13 LFO Phase Difference -180deg – +180deg (4 – 124)
No. Parameter Range Value Table No.
01 Sensitivity 0 – 127 (0 – 127)
02 Dyna Level Offset 0 – 127 (0 – 127)
03 Feedback Level -63 – +63 (1 – 127)
04 Attack Time 0.3ms – 227ms (0 – 127) 17
05 Release Time 2.6ms – 2171ms (0 – 127) 18
06 Release Curve 0 – 127 (0 – 127)
07 Direction up, down (0 – 1)
08 Dyna Threshold Level 0 – 127 (0 – 127)
10 Dry / Wet Balance D63>W – D=W – D<W63 (1 – 127)
11 Stage 4, 5, 6 (4 – 6)
13 EQ Low Frequency 32Hz – 2.0kHz (4 – 40) 3
14 EQ Low Gain -12dB – +12dB (52 – 76)
15 EQ High Frequency 500Hz – 16.0kHz (28 – 58) 3
16 EQ High Gain -12dB – +12dB (52 – 76)
No. Parameter Range Value Table No.
01 LFO Speed 0.0Hz – 39.70Hz (0 – 127) 1
02 AM Depth 0 – 127 (0 – 127)
03 PM Depth 0 – 127 (0 – 127)
06 – 09: Same as marked with *.
11 EQ Mid Frequency 100Hz – 10.0kHz (14 – 54) 3
12 EQ Mid Gain -12dB – +12dB (52 – 76)
13 EQ Mid Width 0.1 – 12.0 (1 – 120)
14 LFO Phase Difference -180deg – +180deg (4 – 124)
15 Input Mode mono/stereo (0 – 1)
30
Data List
Effect Parameter List