ENGINE SPECIFICATIONS
2-2
EAS20290
ENGINE SPECIFICATIONS
Engine
Engine type Air cooled 4-stroke, OHV
Displacement 1670.0 cm³
Cylinder arrangement V-type 2-cylinder
Bore × stroke 97.0 × 113.0 mm (3.82 × 4.45 in)
Compression ratio 8.40 :1
Standard compression pressure (at sea level) 1200 kPa/200 r/min (170.7 psi/200 r/min) (12.0
kgf/cm²/200 r/min)
Minimum–maximum 1000–1400 kPa (142.2–199.1 psi) (10.0–14.0
kgf/cm²)
Starting system Electric starter
Fuel
Recommended fuel Regular unleaded gasoline only (Europe) (ZA)
Unleaded gasoline only (AUS)
Fuel tank capacity 15.0 L (3.96 US gal) (3.30 Imp.gal)
Fuel reserve amount 3.0 L (0.79 US gal) (0.66 Imp.gal)
Engine oil
Lubrication system Dry sump
Type SAE20W40
Recommended engine oil grade API service SG type or higher, JASO standard
MA
Engine oil quantity
Total amount 5.00 L (5.29 US qt) (4.40 Imp.qt)
Engine 2.2 L (2.33 US qt) (1.94 Imp.qt)
Oil tank 2.8 L (2.96 US qt) (2.46 Imp.qt)
Without oil filter cartridge replacement 3.70 L (3.91 US qt) (3.26 Imp.qt)
With oil filter cartridge replacement 4.10 L (4.33 US qt) (3.61 Imp.qt)
Oil filter
Oil filter type Cartridge (paper)
Oil pump
Oil pump type Trochoid
Inner-rotor-to-outer-rotor-tip clearance Less than 0.12 mm (0.0047 in)
Limit 0.20 mm (0.0079 in)
Outer-rotor-to-oil-pump-housing clearance 0.09–0.15 mm (0.0035–0.0059 in)
Limit 0.220 mm (0.0087 in)
Oil-pump-housing-to-inner-and-outer-rotor
clearance 0.03–0.08 mm (0.0012–0.0032 in)
Limit 0.150 mm (0.0059 in)
Bypass valve opening pressure 80.0–120.0 kPa (11.6–17.4 psi) (0.80–1.20
kgf/cm²)
Relief valve operating pressure 60.0 kPa (8.7 psi) (0.60 kgf/cm²)
Spark plug (s)
Manufacturer/model NGK/DPR7EA-9
Manufacturer/model DENSO/X22EPR-U9
Spark plug gap 0.8–0.9 mm (0.031–0.035 in)
To Next Page
Loading...
