Yamaha MT125A - Page 38

FOR YOUR SAFETY – PRE-OPERATION CHECKS
4-3
4
Chassis fasteners
• Make sure that all nuts, bolts and screws are properly tightened.
• Tighten if necessary.
—
Instruments, lights, signals
and switches
• Check operation.
• Correct if necessary.
—
Sidestand switch
• Check operation of ignition circuit cut-off system.
• If system is not working correctly, have Yamaha dealer check vehicle.
3-18
Battery
• Check fluid level.
• Fill with distilled water if necessary.
6-30
ITEM CHECKS PAGE
U5D7E4E0.book Page 3 Thursday, July 10, 2014 3:01 PM