Yamaha MTX5-D - Page 9

AMX Control Module for: MTX5-D Matrix Processor Rev.1
9
Send Commands & Status Strings
Input:Gate:Attack=<In #>:<0-1000|+|->
Input:Gate:Decay=<In #>:<0-1000|+|->
Input:Gate:Hold=<In #>:<0-1000|+|->
Input:Gate:On=<In #>:<0-1|T>
Input:Gate:Range=<In #>:<0-1000|+|->
Input:Gate:Threshold=<In #>:<0-1000|+|->
Input:Gate=In <1-16>: Threshold <0-1000>,Range <0-1000>,Attack <0-1000>,Decay <0-1000>,
Hold <0-1000>, On <0 Off|1 On>
Input:HPF:Freq=<In #>:<0-1000>
Input:HPF:On=<In #>:<0-1|T>
Input:HPF=In <1-16>:Freq <0-1000>,On <0 Off|1 On>
Input:Volume=<In #>:<0-1000|+|->
Input:On=<In #>:<0-1|T>
Input=In <1-34>:Vol <0-1000>,On <0 Off|1 On>
Input:Patch=<In #>:<Audio Source #>
Input=In <1-30>:Input <0-62>
Input:Phase=<In #>:<0-1|T>
Input:Phase=In <1-16>:<1 (INVERTED)|0 (NORMAL)>
InputDCA:Volume=<In DCA #>:<0-1000|+|->
InputDCA:Mute=<In DCA #>:<0-1|T>
InputDCA =In <1-8>:Vol <0-1000>,Mute <0 (UNMUTED)|1 (MUTED)>
MatrixOutput:Volume=<MatrixOut #>:<0-1000|+|->
MatrixOutput:On=<MatrixOut DCA #>:<0-1|T>
MatrixOutput=Out <1-16>:Vol <0-1000>,On <0 Off|1 On>
MatrixSend:Volume=<In #>,<Send #>:<0-1000|+|->
MatrixSend:On=<In #>,<Send #>:<0-1|T>
MatrixSend=In <1-34>,Send <0-16>:Vol <0-1000>,On <0 Off|1 On>
Meters:Start=<Meter Group #>,<Level|Hold>,<Refresh Interval (msec)>
Meters:Stop-<Meter Group #>
No status message – meters are sent as levels to vdvMeter. See Command/String Index Values.
Output:EQ:Freq=<Out #>,<Band 1-4>:<0-1000|+|->
Output:EQ:Gain=<Out #>,<Band 1-4>:<0-1000|+|->
Output:EQ:Q=<Out #>,<Band 1-4>:<0-1000|+|->
Output:EQ:Type=<Out #>,<Band 1-4>:<1-7>
Output:EQ:BandBypass=<Out #>,<Band 1-4>:<1-7>
Output: EQ=Out <1-16>,Band <1-4>:Gain <0-1000>, Freq <0-1000>, Q <0-1000>,
Type<1-7>, BandBypass <1 (BYPASS)|0 (ENGAGE)>
Output:EQ:On=<Out #>:<0-1|T>
Output:EQ:On=Out <1-16>:<0-1|T>