Yamaha RX-595 User Manual

Natural Sound Stereo Receiver
80W + 80W (8Ω) RMS Output Power, 0.019% THD, 20–20,000 Hz
High Dynamic Power, Low Impedance Drive Capability
Continuously Variable Loudness Control
CD DIRECT AMP Switch to Reproduce the Purest CD Sound
PURE DIRECT Switch to Reproduce the Purest Source Sound
40-Station Random Access Preset Tuning
Automatic Preset Tuning
Preset Station Shifting Capability (Preset Editing)
IF Count Direct PLL Synthesizer Tuning System
Video Signal Input/Output Capability
Remote Control Capability
Thank you for selecting this YAMAHA stereo receiver.
CONTENTS
Safety Instructions ................... 2
Supplied Accessories .............. 3
Connections ............................. 4
Basic Operations ...................... 7
Tuning Operations .................. 10
Preset Tuning ......................... 11
Remote Control Transmitter ... 13
Troubleshooting ...................... 15
Specifications ......................... 16
IMPORTANT!
Please record the serial number of this
unit in the space below.
Serial No.:
The serial number is located on the rear
of the unit.
Retain this Owner’s Manual in a safe
place for future reference.
WARNING
TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE
THIS UNIT TO RAIN OR MOISTURE.
RISK OF ELECTRIC
SHOCK
CAUTION: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK), NO USER-SERVICEABLE
PARTS INSIDE, REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead
symbol, within an equilateral triangle,
is intended to alert you to the
presence of uninsulated “dangerous
voltage” within the product’s
enclosure that may be of sufficient
magnitude to constitute a risk of
electric shock to persons.
The exclamation point within an
equilateral triangle is intended to alert
you to the presence of important
operating and maintenance
(servicing) instructions in the
literature accompanying the
appliance.
•
Explanation of Graphical Symbols
CAUTION
OWNER’S MANUAL
RX-595

Yamaha RX-595 Specifications

Audio Specifications

minimum RMS output power per channel (8 ohms, 20 Hz to 20 kHz, 0.019% THD)	80W+80W
minimum RMS output power per channel (6 ohms, 20 Hz to 20 kHz, 0.038% THD)	90W+90W
dynamic power per channel (8/6/4/2 ohms)	120/140/180/200W
power band width (8 ohms, 40W, 0.038% THD)	10 Hz to 50 kHz
damping factor (speakers A, 8 ohms, 20 Hz to 20 kHz)	240 or more
maximum power (EIAJ, 8 ohms)	130W
maximum power (EIAJ, 6 ohms)	150W
input sensitivity/impedance (phono MM)	2.5 mV/47 k-ohms
input sensitivity/impedance (CD/TAPE/LD·TV/VCR)	150 mV/47 k-ohms
maximum input signal (phono MM, 1 kHz, 0.003% THD)	115 mV
output level/impedance (REC OUT)	150 mV/470 ohms
headphone jack rated output/impedance (RL = 8ohms, 0.019% THD)	0.3V/680 ohms
frequency response (CD/TAPE/LD·TV/VCR, 20 Hz to 20 kHz)	0±0.5 dB
RIAA equalization deviation (phono MM)	0±0.3 dB
total harmonic distortion (phono MM to REC OUT, 20 Hz to 20 kHz, 3V)	0.003%
total harmonic distortion (CD/TAPE/LD·TV/VCR to SP OUT, 20 Hz to 20 kHz, 40W/8 ohms)	0.008%
intermodulation distortion (CD/TAPE/LD·TV/VCR, rated output/8 ohms)	0.01%
signal-to-noise ratio (IHF-A Network, phono MM, 5 mV input shorted)	88 dB
signal-to-noise ratio (IHF-A Network, CD/TAPE/LD·TV/VCR, input shorted, effect off)	110 dB
residual noise (IHF-A Network, CD direct amp on)	35 µV
residual noise (IHF-A Network, pure direct on)	90 µV
channel separation (CD/TAPE/LD·TV/VCR, input 5.1 k-ohms terminated 1 kHz/10 kHz)	65 dB/50 dB
tone control characteristics (bass boost/cut)	±10 dB (20 Hz)
tone control characteristics (treble boost/cut)	±10 dB (20 kHz)
turnover frequency (bass)	350 Hz
turnover frequency (treble)	3.5 kHz
continuous loudness control	–30 dB (1 kHz)
gain tracking error (0 to –60 dB)	2 dB

Video Specifications

input level/impedance	1 Vp-p/75 ohms
output level/impedance	1 Vp-p/75 ohms

FM Specifications

tuning range (U.S.A. and Canada models)	87.5 to 107.9 MHz
tuning range (Australia and General models)	87.5 to 108.0 MHz
50 dB quieting sensitivity (mono, IHF, 75 ohms)	1.55 µV (15.1 dBf)
50 dB quieting sensitivity (stereo, IHF, 75 ohms)	21 µV (37.7 dBf)
usable sensitivity (75 ohms, 30 dB S/N quieting, 1 kHz, 100% mod.)	0.8 µV (9.3 dBf)
DIN, mono (S/N 26 dB)	0.9 µV
DIN, stereo (S/N 46 dB)	24 µV
image response ratio	45 dB
IF response ratio	80 dB
spurious response ratio	70 dB
AM suppression ratio	55 dB
capture ratio	1.5 dB
alternate channel selectivity	85 dB
signal-to-noise ratio (IHF, mono/stereo)	80 dB/75 dB
harmonic distortion (1 kHz, mono/stereo)	0.1/0.2%
stereo separation (1 kHz)	50 dB
frequency response (20 Hz to 15 kHz)	0 ±1.5 dB

AM Specifications

tuning range (U.S.A., Canada and General models)	530 to 1, 710 kHz
tuning range (Australia model)	531 to 1, 611 kHz
usable sensitivity	100 µV/m
selectivity	32 dB
signal-to-noise ratio	50 dB
image response ratio	40 dB
spurious response ratio	50 dB
harmonic distortion (400 Hz)	0.3%

General Specifications

power supply (U.S.A. and Canada models)	AC 120V, 60 Hz
power supply (Australia model)	AC 240V, 50 Hz
power supply (General model)	AC 110/120/220/240V, 50/60 Hz
power consumption (U.S.A. model)	190 W
power consumption (Canada model)	250 W/320 VA
power consumption (Australia and General models)	210W
AC outlets (U.S.A., Canada and General models)	2 switched outlets, 100W max. total
AC outlets (Australia model)	1 switched outlet, 100W max. total
dimensions (W x H x D)	435 x 146 x 386 mm (17-1/8” x 5-3/4” x 15-3/16”)
weight	9.5 kg (20 lbs. 14 oz.)