Why is my Yamaha RX-V1067 Receiver remote control not working?
If your Yamaha Receiver's remote control isn't working, first, ensure you're within a 6-meter range and a 30-degree angle from the front panel. Strong sunlight or certain lights may interfere, so adjust the lighting or reposition the unit. Weak batteries can also be the culprit; try replacing them. Finally, check that the remote control ID matches the receiver's ID.
General| Receiver type | - |
|---|---|
| RMS rated power | 1155 W |
| Pre-out channels | 7.2 |
| Pre-out connectivity | Yes |
| Audio output channels | 7.2 channels |
| Signal-to-Noise Ratio (SNR) | 100 dB |
| Total Harmonic Distortion (THD) | 0.04 % |
| Dynamic power per channel (4 Ohm) | 210 W |
| Power output per channel (1KHz@8 Ohm) | 120 W |
| Power output per channel (20-20KHz@8 Ohm) | 105 W |
| HDMI in | 8 |
| Audio (L/R) in | 10 |
| Remote (IR) input | 1 |
| Composite video in | 5 |
| Digital audio coaxial in | 3 |
| Multichannel audio input type | RCA |
| Component video (YPbPr/YCbCr) in | 4 |
| Number of HDMI outputs | 2 |
| Digital audio coaxial out | 0 |
| Connectivity technology | Wired |
| Speakers connectivity type | Clamp terminals |
| Audio formats supported | AAC, FLAC, MP3, WAV, WMA |
| Wi-Fi | No |
| Supported radio bands | AM, FM |
| Internet radio services supported | Napster |
| Supported video modes | 1080p |
| Supported graphics resolutions | 1920 x 1080 (HD 1080) |
| Product color | Black |
| Audio decoders | Dolby Digital Plus, Dolby Pro Logic IIx, Dolby Pro Logic IIz, Dolby TrueHD, DTS-HD |
| Volume control | Rotary |
| Apple docking compatibility | Not supported |
| Graphical user interface (GUI) language | English, French, German, Russian, Spanish |
| Power consumption (standby) | 0.3 W |
Weight and Dimensions| Depth | 430 mm |
|---|---|
| Width | 435 mm |
| Height | 182 mm |
| Weight | 14700 g |
To Next Page
