4-94-8
Bearing Housing
➀ Bearing housing grease nipple
Grease the bearing housing through
the grease nipple.
The first service should be done after
10 hours or 1 month by your Yamaha
dealer.
Fill the bearing housing with water
resistant grease through the grease
nipple.
After first service: Every 100 hours or 6
months (you may do this yourself)
Fill the grease slowly and carefully,
because it can damage the hose and
the joints.
Recommended water-resistant
grease:
Yamaha Marine Grease, or
Yamaha Grease A
Grease capacity: 33.0~35.0 cc
(1.11~1.18 oz)
Grease capacity: 6.0~8.0 cc
(0.20~0.27 oz)
GREASE POINTS
To keep moving parts sliding or rotating
smoothly, coat them with water resis-
tant grease such as Yamaha Marine
Grease, Yamaha Grease A, or an equiv-
alent.
Throttle Cable
Grease the throttle-cable inner wires at
the carburetors.
Steering Cable Ball Joints and Inner
Wire
Grease the steering cable and shift
cables ball joints at the steering noz-
zles. Extend the steering cable and
shift cable inner wires and apply a thin
coat of grease to them.
Pivot Points
Grease all pivot points of the steering
and shift mechanism at the pump end.
MAINTENANCE & CARE 4
4
MAINTENANCE & CARE
*SR230(2003)-OwnMnl 3/21/03 2:10 PM Page 4-8
To Next Page
Loading...
