EasyManua.ls Logo

Yamaha T-80 Service Manual

Yamaha T-80
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
STEREO
TUNER
I(FRON+
PANEL
HCONTENTS
.........................
TO SRVICE PERSONAL
1
.............................
SPEClFICATlONS
1
...............................
REARPANELS
2
.....................
DISASSEMBLY PROCEDURES 3
.............................
INTERNALVIEW 4
.............
.............
ADJUSTMENT
...
4
19
BLOCKDIAGRAM
.............................
10
PRINTED ClRGUlT BOARD
...................
11 13
WIRING DIAGRAM
.........................
14.
15
SCHEMATIC DIAGRAM
......................
16.
17
EXPLODED VIEW
.............................
18
PARTS LIST
............................
19
27
NIPPON GAKKl
CO.,
LTD
.
HAMAMATSU
.
JAPAN
1
IW-qQl
Printpd
in
laoan

Other manuals for Yamaha T-80

Question and Answer IconNeed help?

Do you have a question about the Yamaha T-80 and is the answer not in the manual?

Yamaha T-80 Specifications

General IconGeneral
Tuning BandsFM, MW
Tuning ScaleAnalog
FM Tuning Range87.5 - 108 MHz
Signal to Noise Ratio (FM)70 dB
Signal to Noise Ratio (AM/MW)50 dB
Distortion (FM)0.3%
Selectivity (FM)50 dB
Weight6.5kg
TypeAnalog
Frequency Response (FM)30Hz to 15kHz
Power SupplyAC 120V, 60Hz

Summary

To Service Personal

Leakage Current Measurement

Procedure to verify proper insulation of conductive surfaces after service.

Specifications

FM Section Specifications

Technical specifications for the FM tuner section, including sensitivity and selectivity.

AM Section Specifications

Technical specifications for the AM tuner section, including tuning range and sensitivity.

Rear Panels

Adjustment - Preparation

Before Adjustment Procedures

Preparation steps before performing any internal adjustments.

FM Tuner Section Adjustment

Procedures and guidance for adjusting the FM tuner section.

Adjustment - FM Tuner Steps

Discriminator Balance Adjustment

Procedure to adjust discriminator balance using an auxiliary center meter.

Tuning Point Set Confirmation

Procedure to confirm the tuning point using an FM signal generator.

Monaural Distortion Adjustment

Procedure to adjust monaural distortion to minimum.

VCO Adjustment

Procedure for adjusting the Voltage Controlled Oscillator (VCO).

PLL Input Phase Adjustment

Procedure to adjust the Phase Locked Loop (PLL) input phase.

Stereo Distortion Adjustment

Procedure to adjust stereo distortion to minimum.

DX Distortion Adjustment

Procedure to adjust distortion in DX mode.

Monaural Distortion Confirmation

Confirmation procedure for minimum monaural distortion.

Adjustment - FM Tuner Steps (Cont.)

Separation Adjustment

Procedure to adjust stereo separation for R and L channels.

Pilot Cancel Adjustment

Procedure to adjust pilot cancel by reducing 19kHz carrier leak.

Full-Scale Signal Level Indicator Adjustment

Procedure to adjust the signal level indicators to light up correctly.

Adjustment - AM Tuner & Digital Control

AM Tuner Section Adjustments

Procedures and guidance for adjusting the AM tuner section.

Adjustment - Functional Confirmation

Tuner Circuit Board Layout

Adjustment Points - VCO

Location for VCO adjustment on the tuner circuit board.

Adjustment Points - Pilot Cancel

Location for pilot cancel adjustment on the tuner circuit board.

Adjustment Points - PLL Phase

Location for PLL input phase adjustment on the tuner circuit board.

Adjustment Points - FM IF Offset

Location for FM IF offset adjustment on the tuner circuit board.

Adjustment Points - Discriminator Balance

Location for discriminator balance adjustment on the tuner circuit board.

Adjustment Points - Monaural Distortion

Location for monaural distortion adjustment on the tuner circuit board.

Adjustment Points - Stereo Distortion

Location for stereo distortion adjustment on the tuner circuit board.

Block Diagram

Wiring Diagram

Schematic Diagram

IC Block Diagram

IC Block Diagram - Continued

Related product manuals