Need help?Do you have a question about the Yamaha TT-R125EW and is the answer not in the manual?
General| Displacement | 124cc |
|---|---|
| Bore x Stroke | 54.0mm x 54.0mm |
| Compression Ratio | 10.0:1 |
| Fuel System | Mikuni VM20 carburetor |
| Ignition System | CDI |
| Transmission | 5-speed |
| Final Drive | Chain |
| Rear Suspension | Single shock; 6.6-in travel |
| Rear Brake | Drum |
| Front Tire | 70/100-19 |
| Rear Tire | 90/100-16 |
| Seat Height | 31.7 in |
| Wet Weight | 198 lb |
| Fuel Capacity | 1.6 gal |
| Wheelbase | 50.0 in |
| Length | 74.2 in |
| Width | 31.3 in |
| Height | 42.7 in |
| Engine Type | Air-cooled, 4-stroke, SOHC, 2-valve |
| Front Suspension | Telescopic fork; 7.1-in travel |
| Ground Clearance | 11.6 in |
| Front Brake | Hydraulic single disc, 220mm |
Details and illustrations of the motorcycle's controls and major parts.
Crucial safety advice and preparation steps before maintenance or disassembly.
Lists and illustrates specialized tools required for maintenance tasks.
Explains the operation of the main switch, starter, and clutch controls.
Provides key technical data including dimensions, weight, and engine type.
Details service tolerances and limits for engine components.
Details service tolerances and limits for chassis components.
Reference guide for standard tightening torques and measurement units.
Comprehensive schedule for regular maintenance tasks and lubrication points.
Essential checks to ensure the motorcycle is in good operating condition.
Procedure for checking and adjusting engine valve clearances.
Maintenance and adjustment procedures for the steering system.
Details on carburetor removal, inspection, and assembly.
Procedures for inspecting, measuring, and servicing cylinder and piston.
Service procedures for the clutch and primary drive gears.
Step-by-step instructions for removing the engine from the frame.
Procedures for removing, inspecting, and installing the front wheel and brake.
Procedures for removing, inspecting, and installing the rear wheel and brake.
Detailed steps for front fork disassembly, inspection, and assembly.
Procedures for inspecting and adjusting the steering head bearings.
Steps for diagnosing and troubleshooting ignition system failures.
Inspection and repair procedures for the electric starting system.
Steps for inspecting and troubleshooting the battery charging system.
To Next Page
