5-2
OPERATION AND IMPORTANT RIDING POINTS
5
ECA00126
cC
If the 2-stroke engine oil level
warning light does not come on,
have a Yamaha dealer check the
electrical circuit.
3. Close the throttle completely.
4. Start the engine by pushing the
start switch or by pushing the
kickstarter lever down, while
applying the front or rear brake.
NOTE:
If the engine fails to start by pushing
the start switch, release the switch,
wait a few seconds, and then try
again. Each starting attempt should
be as short as possible to preserve
the battery. Do not crank the engine
more than 5 seconds on any one
attempt. If the engine does not start
with the starter motor, try using the
kickstarter.
ECA00055
cC
For maximum engine life, always
warm the engine up before starting
off. Never accelerate hard when
the engine is cold!
1. Start switch “,”
2. Kickstarter
EAU04473
Starting off
NOTE:
Before starting off, allow the engine
to warm up.
1. While pulling the rear brake lever
with your left hand and holding
the carrier with your right hand,
push the scooter off the center-
stand.
2. Sit astride the seat, and then
adjust the rear view mirrors.
3. Switch the turn signal on.
To Next Page
Loading...
Need help?
General