6-8
PERIODIC MAINTENANCE AND MINOR REPAIR
6
EAU04349
Cleaning the air filter sponge
material
The air filter sponge material should
be cleaned at the intervals specified
in the periodic maintenance and lubri-
cation chart. Clean the air filter
sponge material more frequently if
you are riding in unusually wet or
dusty areas.
1. Remove panel A. (See page 6-4
for panel removal and installation
procedures.)
1. Air filter case cover
2. Screw (×3)
3. Pull the air filter sponge material
out, clean it with solvent, and
then squeeze the remaining sol-
vent out.
EW000075
w
Use only a dedicated parts clean-
ing solvent. To avoid the risk of
fire or explosion, do not use gaso-
line or solvents with a low flash
point.
1. Air filter sponge material
2. Remove the air filter case cover
by removing the screws, then
pulling the cover off while
squeezing the clamp.
ECA00086
cC
Make sure that no foreign material
enters the carburetor intake.
1. Clamp
2. Carburetor intake
5LY-9-13 (US) 4/23/02 4:16 PM Page 44
To Next Page
Loading...
Need help?
General
